Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in 049
Multiple Choice Question in
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in 2016
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. In helical bevel gearing, the axes of shafts are __________ and the teeth are curved.
(A): intersecting
(B): non-intersecting and non-parallel
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->A sliding mesh gearbox has a gear ratio 4:1 at the third gear position. The clutch shaft gear has 15 teeth and its mating lay shaft gear is having 45 teeth. If the main shaft gear contains 28 teeth, the mating lay shaft gear should have:....
QA->Kerala-based private sector lender Federal Bank is openingincubation centres for startups in __________ and __________.....
QA->Capital gearing refers to the relationship between equity capital and :....
QA->A Hook’s joint in a automobile transmission system is preferred when the driving and driven shafts are:....
QA->The type of gears used for transmitting power between two-non intersecting perpendicular shafts is :....
MCQ->In helical bevel gearing, the axes of shafts are __________ and the teeth are curved.....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface :1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area.2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface.3. The resultant force on a curved surface acts on the bottom of th6 curved surface.Of these statements :....
MCQ->In skew bevel gearing, the axes of shafts are....
MCQ->When bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and one of the bevel gears has a pitch angle of 90°, then they are known as....
MCQ->When bevel gears having equal teeth and equal pitch angles connect two shafts whose axes intersect at right angle, then they are known as....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions