1. The instrument used to determine the rotation speed of a shaft is called





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A sliding mesh gearbox has a gear ratio 4:1 at the third gear position. The clutch shaft gear has 15 teeth and its mating lay shaft gear is having 45 teeth. If the main shaft gear contains 28 teeth, the mating lay shaft gear should have:....
QA->Which transmission unit is used to turn the driven shaft faster than the driving shaft?....
QA->A car during its journey travels 30 minutes at the speed of 40 km/hr. another 45 minutes at the speed of 60 km /hr and for two hours at a speed of 70 km/hr. Find the average speed of the car?....
QA->Tyre rotation is a recommended method to equalize the tyre wear. In doing the tyre rotation, generally, the spare wheel will be fitted to the :....
QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....
MCQ->The 2-kg shaft CA passes through a smooth journal bearing at B. Initially, the springs, which are coiled loosely around the shaft, are unstretched when no force is applied to the shaft. In this position s = sª = 250 and the shaft is originally at rest. If a horizontal force of F = 5 kN is applied, determine the speed of the shaft at the instant s = 50 mm, sª = 450 mm. The ends of the springs are attached to the bearing at B and the caps at C and A.....
MCQ->A slender shaft supported on two bearings at its ends carries a disc with an eccentricity e from the axis of rotation. The critical speed of the shaft is Nc. If the disc is replaced by a second one of same mass but mounted with an eccentricily 2 e, then the critical speed of the shaft in the second case is....
MCQ->A torsional system with discs of moment of inertia I1 and I2 as shown in the below figure, is gear driven such that the ratio of speed of shaft B to shaft A is 'G'. Neglecting the inertia of gears, the equivalent inertia of disc on shaft B at the speed of shaft A is equal to....
MCQ->The instrument used to determine the rotation speed of a shaft is called....
MCQ->The following data refers to two crossed helical gears used for speed reduction. Gear I: Pitch circle diameter in the plane of rotation 80 mm and helix angle 30°. Gear II: Pitch circle diameter in the plane of rotation 120 mm and helix angle 22.5°. If the input speed is 1280 rpm, the output speed in rpm is :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions