1. The funnel shaped tube at the ovarian end of oviduct is called





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The funnel shaped tube at the ovarian end of oviduct is called:....
QA->An abnormality occurs in egg yolk as a result of the hemorrhage of small blood vessels in the ovary or oviduct:....
QA->The part of oviduct where egg white is secreted around the yolk:....
QA->The process by which heat is transferred from the hotter end to the colder end of an object is known as ______ :....
QA->A program Graph has ‘start’ and ‘end’ nodes. The total number of paths from start to end is equivalent to the -----------set of test data required to test the software.....
MCQ->The funnel shaped tube at the ovarian end of oviduct is called....
MCQ-> DIRECTIONS for the following three questions: Answer the questions on the basis of the information given below.A city has two perfectly circular and concentric ring roads, the outer ring road (OR) being twice as long as the inner ring road (IR). There are also four (straight line) chord roads from E1, the east end point of OR to N2, the north end point of IR; from N1, the north end point of OR to W2, the west end point of IR; from W1, the west end point of OR, to S2, the south end point of IR; and from S1 the south end point of OR to E2, the east end point of IR. Traffic moves at a constant speed of $$30\pi$$ km/hr on the OR road, 20$$\pi$$ km/hr on the IR road, and 15$$\sqrt5$$ km/hr on all the chord roads.The ratio of the sum of the lengths of all chord roads to the length of the outer ring road is
 ....
MCQ->A violent whirlwind characterised by a black funnel-shaped cloud hanging from heavy cumulonimbus is know by the name of?....
MCQ->Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally __________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8").....
MCQ->A torsion member is fabricated from two concentric thin tubes. At the ends, the tubes are welded to rigid discs so that both the tubes are twisted as a unit. The radius of the outer tube is 2r and that of the inner tube is r. If the shear stresses developed in the outer tube is τ, then the shear stress in the inner tube will be.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions