TRADESMAN---TURNING---TECHNICAL-EDUCATION Related Question Answers

1. Which of the following is a mesomorphous material?

2. #NAME?

3. Fillet gauges are available in standard radii from

4. The cutting edges need to be honed with special grinding stricks called

5. Form tools have a much longer cutting edge than

6. This method of marking is used on

7. Made of a surface plate

8. The marking table provides a

9. Angle of a prick punch

10. Scriber points are very

11. The hermaphrodite caliper is generally used to locate

12. The Lathe Centres are provided with standard taper known as :

13. The chuck used for setting up of heavy and irregular shaped work should be ?

14. The Chamfaring is an essential operation after :

15. Least count of steel rule is :

16. The heat treatment process for softening hardened steel is :

17. Steel containing 0.8 to 1.5% carbon is known as :

18. A lathe with four steps on the cone pulley and with back gears will have :

19. Least count of vernier caliper metric is :

20. For turning internal tapers, the suitable method is:

21. The percentage of carbon in cast iron varies from :

22. The correct order of increasing hot hardness of cuttingtool materials:

23. Americannational standard thread is :

24. A single point thread cutting tool should ideally have :

25. The alloy, mainly used for corrosion resistance instainless is

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use