1. A single-curved surface is a developable ruled surface that can be unrolled to coincide with a cylinder.



Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Cylinder block construction by mono-block is preferred to individual cylinder construction because of?....
QA->A loose fit between a dry cylinder liner and cylinder block would cause:....
QA->Which is not an advantage of multi cylinder air cooled engines when compared to multi cylinder water cooled engines?....
QA->That which can easily be curved without breaking....
QA->That which can easily be curved without breaking.....
MCQ->A single-curved surface is a developable ruled surface that can be unrolled to coincide with a cylinder.....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface :1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area.2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface.3. The resultant force on a curved surface acts on the bottom of th6 curved surface.Of these statements :....
MCQ->What is the volume of the cylinder (in cubic metre)? (I) The sum of height and radius of the cylinder is 24m. The total surface area of the cylinder is 2112 sq. m. (II) LCM and HCF of the numerical values of the radius and height of the cylinder are 70 and 2 respectively. The square of numerical values of the radius of the cylinder is 96 more than the square of the numerical value of the height of the cylinder.....
MCQ->The respective ratio of curved surface area and total surface area of a cylinder is 4:5. If the curved surface area of the cylinder is 1232 cm2, what is the height ? (in cm)....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions