Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in
Multiple Choice Question in 049
Multiple Choice Question in 2016
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. The purpose of a cylinder head gasket is to
(A): prevent the combustion gases from leaking from the joint between the cylinder block and the cylinder head
(B): prevent engine oil from going into combustion chamber
(C): removes impurities from cylinder head lubricating oil
(D): none of the above
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->Cylinder block construction by mono-block is preferred to individual cylinder construction because of?....
QA->A loose fit between a dry cylinder liner and cylinder block would cause:....
QA->Which is not an advantage of multi cylinder air cooled engines when compared to multi cylinder water cooled engines?....
QA->For the purpose of convenience the Head office of NABARD is divided into two departments. They are:....
QA->Reboring of an engine cylinder to the next oversize would slightly....
MCQ->What is the volume of the cylinder (in cubic metre)? (I) The sum of height and radius of the cylinder is 24m. The total surface area of the cylinder is 2112 sq. m. (II) LCM and HCF of the numerical values of the radius and height of the cylinder are 70 and 2 respectively. The square of numerical values of the radius of the cylinder is 96 more than the square of the numerical value of the height of the cylinder.....
MCQ->The purpose of a cylinder head gasket is to....
MCQ->The following steps are involved in making a spigot and socket joint of cast iron pipes used in water supply systems :1. Tarred gasket or hemp yarn in wrapped around the spigot.2. The sipgot end is centered into the socket end of the preceding pipe.3. A joining ring end is placed around the barrel and against the face of the socket.4. The gasket or hemp yarn in caulked slightly.5. Molten pig lead is poured and then caulked.The correct sequence of these steps is....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
MCQ->A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions