1. A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Whichcountry’s scientists have developed a bacteria-powered battery (bio-battery) ona single sheet of paper, which is capable ofpowering disposable electronics?....
QA->The voltage regulator in the combined voltage and current regulator of a d.c charging circuit contains....
QA->The part of a torque converter that facilitates change of torque between input and output shaft is the:....
QA->The state of charge of a lead acid battery under actual operating conditions can be tested by :....
QA->What is the charge of a torch battery?....
MCQ->A single phase half wave converter is used to charge a battery of 50 V. The thyristor is continuously fired by dc signal. Input voltage is v = Vm sin ωt. The thyristor will conduct....
MCQ->The value of the expression $$Sin^{2}1^\circ+Sin^{2}11^\circ+Sin^{2}21^\circ+Sin^{2}31^\circ+Sin^{2}41^\circ+Sin^{2}45^\circ$$$$+Sin^{2}49^\circ+Sin^{2}59^\circ+Sin^{2}69^\circ+Sin^{2}79^\circ+Sin^{2}89^\circ$$....
MCQ->Consider the following statements for a driving point function F(jω): Re F(jω) is an even function of ω and is 0 or positive for all values of ω.Im F(jω) is an even function of ω and is 0 or positive for all values of ω.Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.Re F(s) = 0 for Re s = 0. Which one of the statements given above is/are correct?....
MCQ->Match the following: List I (Circuits) List II (Output dc voltage)A.Single phase half wave converter1.B.Fully controlled bridge converter (1 phase) with RLE load2.C.3 Phase full converter3.D.Single phase full wave converter (M-2) connection4.

....
MCQ-> Answer the questions based on the following information. In a motor race competition certain rules are given for the participants to follow. To control direction and speed of the motorists, guards are placed at different signal points with caps of different colour. Guard with red cap indicates the direction of participant’s movement and guards with green cap indicates the speed of the participant’s movement. At any signal point presence of three guards, two guards and one guard with red cap means the participant must stop, turn left and turn right respectively. Signal points with three guards, two guards and one guard with green cap means the participants must move at 10, 4 and 2 km/hour respectively. Kartikay, one of the participants, starts at a point where his car was heading towards north and he encountered signals as follows: at start point one guard with green cap; after half an hour two guards with red cap and two guards with green cap at first signal; after fifteen minutes one guard with red cap at second signal; after half an hour one guard with red cap and three guards with green caps at third signal; after 24 minutes two guard with red cap and two guards with green cap at fourth signal; after 15 minutes three guard with red cap at fifth signal. (Time mentioned in each case is applicable after crossing the previous signal).Total distance travelled by Kartikay from starting point till last signal is:
 ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions