1. Match the following: List I (Circuit) List II (Characteristics) A.Darlington pair1.uses pnp and npn transistors used as power amplifierB.CB amplifier2.Voltage gain nearly 1 and high input impedanceC.Cascade amplifier3.low input impedance used for high frequency isolation





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The voltage regulator in the combined voltage and current regulator of a d.c charging circuit contains....
QA->The impedance in an LCR circuit in which the inductive reactance is equal to the cacacitive reactance:....
QA->At the time of short-circuit; what will be the current in the circuit?....
QA->At the time of short-circuit, what will be the current in the circuit?....
QA->The importance of plant tissue and cell culture in isolation was first proposed by ......?....
MCQ->Match the following: List I (Circuit) List II (Characteristics) A.Darlington pair1.uses pnp and npn transistors used as power amplifierB.CB amplifier2.Voltage gain nearly 1 and high input impedanceC.Cascade amplifier3.low input impedance used for high frequency isolation

....
MCQ->Match the following: List I List II A.Darlington amplifier1.A circuit using pnp and npn transistorsB.CB amplifier2.A CS amplifier driving a CG amplifierC.Cascade amplifier3.A circuit with over-all voltage gain close to 1 and very large input impedanceD.Complementary symmetry amplifier4.A circuit with low input impedance

....
MCQ->Match the following: List I List II A.RC coupled amplifier1.Very low driftB.Tuned amplifier2.Flat frequency response from zero frequency onwardsC.Chopper stabilized amplifier3.Flat frequency response with upper and lower cut off frequencyD.DC amplifier4.Peak in gain frequency response

....
MCQ->Match the following: List I List II A.Wein bridge oscillator1.Low output impedanceB.Voltage shunt feedback amplifier2.RF frequency rangeC.Crystal oscillator3.Audio frequency rangeD.Current shunt feedback amplifier4.High input impedance 5.High output impedance

....
MCQ-> In the table below is the listing of players, seeded from highest (#1) to lowest (#32), who are due to play in an Association of Tennis Players (ATP) tournament for women. This tournament has four knockout rounds before the final, i.e., first round, second round, quarterfinals, and semi-finals. In the first round, the highest seeded player plays the lowest seeded player (seed # 32) which is designated match No. 1 of first round; the 2nd seeded player plays the 31st seeded player which is designated match No. 2 of the first round, and so on. Thus, for instance, match No. 16 of first round is to be played between 16th seeded player and the 17th seeded player. In the second round, the winner of match No. 1 of first round plays the winner of match No. 16 of first round and is designated match No. 1 of second round. Similarly, the winner of match No. 2 of first round plays the winner of match No. 15 of first round, and is designated match No. 2 of second round. Thus, for instance, match No. 8 of the second round is to be played between the winner of match No. 8 of first round and the winner of match No. 9 of first round. The same pattern is followed for later rounds as well.If there are no upsets (a lower seeded player beating a higher seeded player) in the first round, and only match Nos. 6, 7, and 8 of the second round result in upsets, then who would meet Lindsay Davenport in quarter finals, in case Davenport reaches quarter finals?
 ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions