1. Match the following: List I (Types of N-bit ADC) List II (Characteristics)A.Flash converter1.Integrating TypeB.Successive2.Fastest converter approximationC.Counter ramp3.Maximum conversion time = N bitsD.Dual slow4.Used a DAC in its feedback path





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->What is the name of the text to speech (TTS) software application jointly developed by IIT-Madras, IIT-Kharagpur, C-DAC Thiruvananthapuram and C-DAC Mumbai for the benefit of farmers?....
QA->A computer with a 32 bit wide data bus implements its memory using 8 K x 8 static RAM chips. The smallest memory that this computer can have is:....
QA->What is the total earnings of a worker from the following data? Standard time for completing the job 50 hours. Actual time taken for completing the job 45 hours. Time rate is Rs.20 per hour, premium bonus is 60% of time saved.....
QA->A three way catalytic converter is used to control the emissions due to :....
QA->Catalytic converter in modern automobiles is used for?....
MCQ->Match the following: List I (Types of N-bit ADC) List II (Characteristics)A.Flash converter1.Integrating TypeB.Successive2.Fastest converter approximationC.Counter ramp3.Maximum conversion time = N bitsD.Dual slow4.Used a DAC in its feedback path

....
MCQ-> In the table below is the listing of players, seeded from highest (#1) to lowest (#32), who are due to play in an Association of Tennis Players (ATP) tournament for women. This tournament has four knockout rounds before the final, i.e., first round, second round, quarterfinals, and semi-finals. In the first round, the highest seeded player plays the lowest seeded player (seed # 32) which is designated match No. 1 of first round; the 2nd seeded player plays the 31st seeded player which is designated match No. 2 of the first round, and so on. Thus, for instance, match No. 16 of first round is to be played between 16th seeded player and the 17th seeded player. In the second round, the winner of match No. 1 of first round plays the winner of match No. 16 of first round and is designated match No. 1 of second round. Similarly, the winner of match No. 2 of first round plays the winner of match No. 15 of first round, and is designated match No. 2 of second round. Thus, for instance, match No. 8 of the second round is to be played between the winner of match No. 8 of first round and the winner of match No. 9 of first round. The same pattern is followed for later rounds as well.If there are no upsets (a lower seeded player beating a higher seeded player) in the first round, and only match Nos. 6, 7, and 8 of the second round result in upsets, then who would meet Lindsay Davenport in quarter finals, in case Davenport reaches quarter finals?
 ....
MCQ->Match the following: List I List II A.Flash converter ADC1.requires conversion time of a few μsB.Dual slope ADC2.requires DACC.Successive approximation ADC3.minimizes the effect of power supply interference 4.requires complex hardware 5.is a tracking ADC

....
MCQ->Match the following: List I (Circuits) List II (Output dc voltage)A.Single phase half wave converter1.B.Fully controlled bridge converter (1 phase) with RLE load2.C.3 Phase full converter3.D.Single phase full wave converter (M-2) connection4.

....
MCQ->Read the following statements The circuitry of ripple counter is more complex than that of synchronous counter.The maximum frequency of operation of ripple counter depends on the modulus of the counter.The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter. Which of the above statements are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions