1. In the following network, the switch is closed at t = 0- and the sampling starts from t = 0. The sampling frequency is 10Hz.The expression and the region of convergence of the z-transform of the sampled signal are





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Data rate of a ring network is 20Mbps and signal propagates at 200m/µsec. The number of bits that can be placed on the channel of length 200km is :....
QA->In UNIX, which of the following system calls transform an executable binary file into a process?....
QA->The Universe in a single atom: The convergence of Science and Spirituality is a book written by whom?....
QA->Scientific Name of Switch Grass ?....
QA->The Bankof Maharashtra has adopted which village to transform it into cashless village?....
MCQ->In the following network, the switch is closed at t = 0- and the sampling starts from t = 0. The sampling frequency is 10Hz.The expression and the region of convergence of the z-transform of the sampled signal are....
MCQ->In the following network, the switch is closed at t = 0 and the sampling starts from t = 0. The sampling frequency is 10Hz.The samples x(n) (n = 0, 1, 2, ...) are given by....
MCQ-> Answer the questions based on the following information. In a motor race competition certain rules are given for the participants to follow. To control direction and speed of the motorists, guards are placed at different signal points with caps of different colour. Guard with red cap indicates the direction of participant’s movement and guards with green cap indicates the speed of the participant’s movement. At any signal point presence of three guards, two guards and one guard with red cap means the participant must stop, turn left and turn right respectively. Signal points with three guards, two guards and one guard with green cap means the participants must move at 10, 4 and 2 km/hour respectively. Kartikay, one of the participants, starts at a point where his car was heading towards north and he encountered signals as follows: at start point one guard with green cap; after half an hour two guards with red cap and two guards with green cap at first signal; after fifteen minutes one guard with red cap at second signal; after half an hour one guard with red cap and three guards with green caps at third signal; after 24 minutes two guard with red cap and two guards with green cap at fourth signal; after 15 minutes three guard with red cap at fifth signal. (Time mentioned in each case is applicable after crossing the previous signal).Total distance travelled by Kartikay from starting point till last signal is:
 ....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions