1. Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switches between





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 km. After this he turns to his left and goes 40 km, then again turns right and goes 10km. How far is he from his starting point?....
QA->The voltage regulator in the combined voltage and current regulator of a d.c charging circuit contains....
QA->The part of a torque converter that facilitates change of torque between input and output shaft is the:....
QA->BIOS (Basic Input Output System) software stored on :....
QA->The amount of input tax that is permitted to be sent off against output tax ?....
MCQ->Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switches between....
MCQ->Consider the following statements, regarding an OP AMP: All types of negative feedback reduce non-linear distortion.All types of negative feedback reduce the output offset voltage.Non-inverting (current and voltage) feedback increases the input impedance.Inverting (current and voltage) feedback decreases input impedance. Which of the above statements is/are correct?....
MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....
MCQ->A Schmitt trigger has VT+ = 2.0 V and VT– = 1.2 V. What is the hysteresis voltage of the Schmitt trigger?....
MCQ->Assertion (A): When a square periodic wave is applied to an RC circuit, the voltage across capacitor is observed to be a triangular periodic wave.Reason (R): The RC circuit works as integrator and its time constant is much larger than time period of input wave.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions