1. In a line VSWR of a load is 6 dB. The reflection coefficient will be





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Coefficient of Temperature depends on....
QA->Mirage is observed in a desert due to the phenomenon of which reflection?....
QA->Total internal reflection can take place when light travels from which thing?....
QA->If temperature rises; what will be the coefficient of viscosity of liquid?....
QA->Total internal reflection of light is possible when light enters from which thing?....
MCQ->In a line VSWR of a load is 6 dB. The reflection coefficient will be....
MCQ->A lossless 50 Ω transmission line is terminated 30 + j25 Ω, then voltage reflection coefficient and current reflection coefficient are....
MCQ->If reflection coefficient is 1/5, then corresponding VSWR is given by....
MCQ-> Study the following information carefully and answer the questions given below: When a word and number arrangement machine is given an input line of words and numbers, it arranges them following a particular rule. The following is an illustration of input and rearrangement : (All the numbers are two digit numbers). Input : bike 51 ride 37 11 duke 58 damp line 75 tent 84 Step I : 84 51 ride 37 11 duke 58 damp line 75 tent bike Step II : 75 84 51 ride 37 11 duke 58 line tent bike damp Step III : 58 75 84 51 ride 37 11 line tent bike damp duke Step IV : 51 58 75 84 ride 37 11 tent bike damp duke line Step V : 37 51 58 75 84 11 tent bike damp duke line ride Step VI : 11 37 51 58 75 84 bike damp duke line ride tent Step VI is the last step of the above arrangement as the intended arrangement is obtained. As per the rules followed in the above steps, find out in each of the following questions the appropriate steps for the given input. Input : find 64 belt 28 54 lamp 17 give flat 69 real 95Which of the following would be the Step III ?
 ....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure :1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile.2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile.3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile.4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays.Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions