1. A clock signal with a period of 1 s is applied to the input of an enable gate. The output must contain six pulses. How long must the enable pulse be active?





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The part of a torque converter that facilitates change of torque between input and output shaft is the:....
QA->BIOS (Basic Input Output System) software stored on :....
QA->The amount of input tax that is permitted to be sent off against output tax ?....
QA->Not a Bernstein’s condition for two processes P1 and P2 executing in parallel on input set I1 and I2, producing output set 0 1 and 0 2 respectively.....
QA->‘International Year of Pulses 2016’ launched by UnitedNations on 10th November 2015 under the theme ------------. UN launched it withthe aim to boost the production of pulses.....
MCQ->A clock signal with a period of 1 s is applied to the input of an enable gate. The output must contain six pulses. How long must the enable pulse be active?....
MCQ-> Study the following information carefully and answer the given questions: A word and number arrangement machine when given an input line of words and numbers rearranges them following a particular rule in each step. The following is an illustration of input and rearrangement. (All the numbers are two digits numbers.)Input : gate 20 86 just not 71 for 67 38 bake sun 55 Step I : bake gate 20 just not 71 for 67 38 sun 55 86 Step II : for bake gate 20 just not 67 38 sun 55 86 71 Step III : gate for bake 20 just not 38 sun 55 86 71 67 Step IV : just gate for bake 20 not 38 sun 86 71 67 55 Step V : not just gate for bake 20 sun 86 71 67 55 38 Step VI : sun not just gate for bake 86 71 67 55 38 20 and Step VI is the last step of the above input as the desired arrangement is reached. As per the rules followed in the above steps, and out in each of the following questions the appropriate step for the given input. Input : 31 rise gem 15 92 47 aim big 25 does 56 not 85 63 with moonHow many steps will be required to complete the rearrangement ?
 ....
MCQ-> Answer the questions based on the following information. In a motor race competition certain rules are given for the participants to follow. To control direction and speed of the motorists, guards are placed at different signal points with caps of different colour. Guard with red cap indicates the direction of participant’s movement and guards with green cap indicates the speed of the participant’s movement. At any signal point presence of three guards, two guards and one guard with red cap means the participant must stop, turn left and turn right respectively. Signal points with three guards, two guards and one guard with green cap means the participants must move at 10, 4 and 2 km/hour respectively. Kartikay, one of the participants, starts at a point where his car was heading towards north and he encountered signals as follows: at start point one guard with green cap; after half an hour two guards with red cap and two guards with green cap at first signal; after fifteen minutes one guard with red cap at second signal; after half an hour one guard with red cap and three guards with green caps at third signal; after 24 minutes two guard with red cap and two guards with green cap at fourth signal; after 15 minutes three guard with red cap at fifth signal. (Time mentioned in each case is applicable after crossing the previous signal).Total distance travelled by Kartikay from starting point till last signal is:
 ....
MCQ->The characteristics of H and V sync pulses in a colour TV receiver are H sync, pulses are narrow and have frequency of 15625 HzV sync, pulses are much wider and have frequency of 50 HzH and V pulses have almost the same size but frequencies of 15625 and 50 Hz respectivelyV sync, pulses are very narrow but H sync, pulses are wide and their frequencies are 15625 Hz and 50 Hz respectively Which of the above are correct?....
MCQ->Which two statements are true for any concrete class implementing the java.lang.Runnable interface? You can extend the Runnable interface as long as you override the public run() method. The class must contain a method called run() from which all code for that thread will be initiated. The class must contain an empty public void method named run(). The class must contain a public void method named runnable(). The class definition must include the words implements Threads and contain a method called run(). The mandatory method must be public, with a return type of void, must be called run(), and cannot take any arguments.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions