Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in
Multiple Choice Question in 049
Multiple Choice Question in 2016
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. Which of the following describes the basic operation of a single-slope A/D converter.
(A): The input voltage is used to set the frequency of a voltage-controlled oscillator (VCO). The VCO quits changing frequency when the input voltage stabilizes. The frequency of the VCO, which is proportional to the analog input voltage, is measured and
(B): A ramp generator is used to enable a counter through a comparator. When the ramp voltage equals the input voltage the counter is latched and then reset. The counter reading is proportional to the input voltage since the ramp is changing at a constant
(C): A ramp voltage and analog input voltage are applied to a comparator. As the input voltage causes the integrating capacitor to charge, it will at some point equal the ramp voltage. The ramp voltage is measured and displayed on the digital panel meter.
(D): Any of the above could be correct, depending on the specific type of A/D converter involved.
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->The basic idea behind Co-operation is:....
QA->The part of a torque converter that facilitates change of torque between input and output shaft is the:....
QA->A three way catalytic converter is used to control the emissions due to :....
QA->Catalytic converter in modern automobiles is used for?....
QA->Which operation was the continuation of operation Desert storm?....
MCQ->Which of the following describes the basic operation of a single-slope A/D converter.....
MCQ-> Study the information given below and answer the questions.The following table contains the pre and post revision pay structure of a Government department
The revision has been done based on the following terms: -In pre-revised pay scale, the basic pay is the sum of the minimum pay in the appropriate pay scale and the admissible increment. After revision, the basic pay is the sum of minimum pay in the appropriate pay scale and the respective grade pay and the admissible increments. -Annual increment of 3% of the basic pay (on a compounded basic) is paid under the revised pay rules. -Monthly Dearness Allowance (DA) is calculated as percentage of basic pay. -In pre-revised pay scales, the increment was given after the completion of each year of service, but, after revision annual increments are given only in the month of July every year and there should be a gap of six months between the increments. The employees who had joined the department in the month of September, October, November and December are given an increment at the time of revised pay fixation in September, 2008. The revised pay is applicable from 1st September, 2008.Abhijit joins the department on November 10, 2006 in the pay scale of Rs. 18,400-500-22,400 with the pay of Rs. 18,400 plus 2 increments. What is his basic salary, after revision, on August 1, 2009?
....
MCQ->Which of the statements below best describes the basic operation of a dual-slope A/D converter?....
MCQ->Which of the following snippets are the correct way to convert a Single into a String? Single f = 9.8f; String s; s = (String) (f); Single f = 9.8f; String s; s = Convert.ToString(f); Single f = 9.8f; String s; s = f.ToString(); Single f = 9.8f; String s; s = Clnt(f); Single f = 9.8f; String s; s = CString(f);....
MCQ->Match the following: List I (Circuits) List II (Output dc voltage)A.Single phase half wave converter1.B.Fully controlled bridge converter (1 phase) with RLE load2.C.3 Phase full converter3.D.Single phase full wave converter (M-2) connection4. ....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Powered By:Omega Web Solutions
The revision has been done based on the following terms:
-In pre-revised pay scale, the basic pay is the sum of the minimum pay in the appropriate pay scale and the admissible increment. After revision, the basic pay is the sum of minimum pay in the appropriate pay scale and the respective grade pay and the admissible increments.
-Annual increment of 3% of the basic pay (on a compounded basic) is paid under the revised pay rules.
-Monthly Dearness Allowance (DA) is calculated as percentage of basic pay.
-In pre-revised pay scales, the increment was given after the completion of each year of service, but, after revision annual increments are given only in the month of July every year and there should be a gap of six months between the increments.
The employees who had joined the department in the month of September, October, November and December are given an increment at the time of revised pay fixation in September, 2008.
The revised pay is applicable from 1st September, 2008.Abhijit joins the department on November 10, 2006 in the pay scale of Rs. 18,400-500-22,400 with the pay of Rs. 18,400 plus 2 increments. What is his basic salary, after revision, on August 1, 2009?