Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in 049
Multiple Choice Question in
Multiple Choice Question in 2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Multiple Choice Question in -current-affairs-2016
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. A counter-ramp ADC stops counting when ________.
(A): the input voltage equals the DAC staircase voltage
(B): the counter reaches a maximum count
(C): the input voltage equals 5 volts
(D): the DAC staircase voltage equals 5 volts
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->If ‘BANK’ is coded as ‘CAMP’ in a language, how is ‘RAMP’ coded in that language?....
QA->Who is the author of the best seller book ‘No Full stops in India’?....
QA->Who is the author of the Book "No Full stops in India" ?....
QA->What is the estimation of age of woody plant by counting annual ring?....
QA->An official counting of the population....
MCQ->A counter-ramp ADC stops counting when ________.....
MCQ->Read the following statements The circuitry of ripple counter is more complex than that of synchronous counter.The maximum frequency of operation of ripple counter depends on the modulus of the counter.The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter. Which of the above statements are correct?....
MCQ-> based on the following information.From a group of 545 contenders, a party has to select a leader. Even after holding a series of meetings, the politicians and the general body failed to reach a consensus. It was then proposed that all 545 contenders be given a number from 1 to 545. Then they will be asked to stand on a podium in a circular arrangement, and counting would start from the contender numbered 1. The counting would be done in a clockwise fashion. The rule is that every alternate contender would be asked to step down as the counting continued, with the circle getting smaller and smaller, till only one person remains standing. Therefore the first person to be eliminated would be the contender numbered 2.Which position should a contender choose if he has to be the leader?
....
MCQ->A stunt driver in car A travels in free flight off the edge of a ramp at C. At the point of maximum height he strikes car B. If the direct collision is perfectly plastic (e = 0), determine the required ramp speed vC at the end of the ramp C, and the approximate distance s where both cars strike the ground. Each car has a mass of 3.5 Mg. Neglect the size of the cars in the calculation.....
MCQ->The resolution of 4 bit counting ADC is 0.5 volt, for an Analog input of 6.6 volts. The digital output of ADC will be....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions