1. Approximate starter pinion-ring gear,gear ratio is:





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A sliding mesh gearbox has a gear ratio 4:1 at the third gear position. The clutch shaft gear has 15 teeth and its mating lay shaft gear is having 45 teeth. If the main shaft gear contains 28 teeth, the mating lay shaft gear should have:....
QA->Highest useful compression ratio is the compression ratio at which the engine....
QA->The ratio of the age of two sisters is 3:The product of their ages is The ratio of their ages after 5 years will be:....
QA->The protein requirement in Broiler starter ration:....
QA->Who is the inventor of Automobile (Self Starter)?....
MCQ->Approximate starter pinion-ring gear,gear ratio is:....
MCQ->A worm gear is used as the pinion for the rack and pinion type of steering gearbox, because it....
MCQ-> DIRECTIONS for the following three questions: Answer the questions on the basis of the information given below.A city has two perfectly circular and concentric ring roads, the outer ring road (OR) being twice as long as the inner ring road (IR). There are also four (straight line) chord roads from E1, the east end point of OR to N2, the north end point of IR; from N1, the north end point of OR to W2, the west end point of IR; from W1, the west end point of OR, to S2, the south end point of IR; and from S1 the south end point of OR to E2, the east end point of IR. Traffic moves at a constant speed of $$30\pi$$ km/hr on the OR road, 20$$\pi$$ km/hr on the IR road, and 15$$\sqrt5$$ km/hr on all the chord roads.The ratio of the sum of the lengths of all chord roads to the length of the outer ring road is
 ....
MCQ->Twenty degree full depth involute profited 21 tooth pinion and 39 tooth gear are in mesh.If the modue is 5 mm,the centre distance between the gear pair will be:....
MCQ->Twenty degree full depth involute profiled 21 tooth pinion and 39 tooth gear are in mesh. If the module is 5 mm, the centre distance between the gear pair will be :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions