1. .Among which of the following conditions a T-beam becomes identical to a rectangular beam with width equal to that of flange?





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Which country’s national flag is the only non-rectangular national flag?....
QA->The length, breadth, height of a rectangular prism are 20cm, 15cm, and 10 cm respectively. Its whole surface area will be :....
QA->One of the conditions required for maintaining National Party Status is among three states a party should win at least:....
QA->The ratio of the width to the length of our national flag is:....
QA->WHAT IS THE RATIO OF WIDTH OF INDIAN NATIONAL FLAG TO ITS LENGTH....
MCQ->.Among which of the following conditions a T-beam becomes identical to a rectangular beam with width equal to that of flange?....
MCQ->Among which of the following conditions a T-beam becomes identical to a rectangular beam with width equal to that of flange?....
MCQ->Consider the following statements in respect of plate girders :1. A large number of cover plates are provided over flange angles so that curtailed flanges match the bending moment diagram exactly.2. At least one cover plate should extend over the entire span so that rain water may not enter and corrode the connections.3. A minimum of one-third of flange area should be provided in flange angles and balance in flange cover plates for stability.Which of the statements given above are correct ?....
MCQ->The following quantities refer to a channel section used as a beam : b = width of flange (upto centre of web thickness).h = depth of web (c/c of flange thickness). t = thickness of flange and web.I = moment of inertia of channel about xx axis.e = distance of shear centre, outside the channel from the mid thickness of the web.The value of 'e' is given by....
MCQ->Gross flange area for a riveted plate girder is to be designed considering net area as 80% of its gross area. Consider width of the flange as 500 mm while web plate as 1000 mm x 12 mm. The girder is to resist a maxi-mum BM of 4500 kNm. Maximum allowable bending stress in tension is 150 MPa. Gross flange area is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions