1. If a solid shaft (diameter 20 cm, length 400 cm, N = 0.8 x 105 N/mm2) when subjected to a twisting moment, produces maximum shear stress of 50 N/mm2, the angle of twist in radians, is






Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A sliding mesh gearbox has a gear ratio 4:1 at the third gear position. The clutch shaft gear has 15 teeth and its mating lay shaft gear is having 45 teeth. If the main shaft gear contains 28 teeth, the mating lay shaft gear should have:....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->Which transmission unit is used to turn the driven shaft faster than the driving shaft?....
QA->Torque transfer at an angle is provided on propeller shaft by using :....
QA->If a liquid wets a solid surface; what is the angle of contact?....
MCQ->If a solid shaft (diameter 20 cm, length 400 cm, N = 0.8 x 105 N/mm2) when subjected to a twisting moment, produces maximum shear stress of 50 N/mm2, the angle of twist in radians, is....
MCQ->Consider the following statements :1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area.2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum.3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum.Of these statements :....
MCQ->The maximum shear stress in a solid shaft of circular cross-section having diameter d subjected to a torque T is τ. If the torque is increased by four times and the diameter of the shaft is increased by two times, the maximum shear stress in the shaft will be....
MCQ->A shaft is subjected to a maximum bending stress of 80 N/mm2 and maximum shearing stress equal to 30 N/mm2 at a particular section. If the yield point in tension of the material is 280 N/mm2 and the maximum shear stress theory of failure is used, then the factor of safety obtained will be....
MCQ->A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions