1. For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Highest useful compression ratio is the compression ratio at which the engine....
QA->The ratio of the age of two sisters is 3:The product of their ages is The ratio of their ages after 5 years will be:....
QA->Upon which development the Second Five Year Plan laid mote stress?....
QA->On which thing did the Buddhism and Jainism both give stress?....
QA->Steel isa form of iron. To make steel from iron, The carbon content is reduced from-....
MCQ->For a steel member of slenderness ratio 350, the allowable stress is 76 kg/cm2 if it is....
MCQ->Consider the following statements :For an over-reinforced (singly reinforced) rectangular RC section.1. the lever arm will be less than that for a balanced section.2. the maximum stress developed by steel would equal the allowable stress in steel.3. the maximum stress developed by concrete would equal allowable stress in concrete.Of these statements :....
MCQ->If the area of cross-section of a single angle discontinuous strut is 30 cm2 and allowable working stress corresponding to its slenderness ratio is 625 kg/cm2, the safe load carrying capacity of the member, is....
MCQ->ABC is rigid bar. It is hinged at A and suspended at B and C by two wires BD and CE made of copper and steel respectively, as shown in the given figure. The bar carries load of 1t at F, mid-way between B and C. Given Ac = 4 cm2, A = 2 cm2, Ec = 1 x 106 kg/cm2, Es = 2 x 106 kg/cm2. Ps is the force in the steel wire and Pc is the force in the copper wire, the ratio Pc/Ps will be

....
MCQ->Consider the following statements :1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area.2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum.3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum.Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions