1. A long plate girder is subjected to a maximum bending moment M in which permitted allowable bending stress is fb. The economical depth de and the thickness of the web tw, is given by


Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The maximum bending moment due to moving load on a simply supported beam, occurs:....
QA->In case of a friction clutch, the pressure plate is held against the clutch plate by :....
QA->On which thing did the Buddhism and Jainism both give stress?....
QA->A _____ is a computer attached to the internet that runs a special web server software and can send web pages out to the other computer over the internet.....
QA->An IT term refers to allowing someone to open web pages and see web sites on the internet.....
MCQ->A long plate girder is subjected to a maximum bending moment M in which permitted allowable bending stress is fb. The economical depth de and the thickness of the web tw, is given by....
MCQ->Gross flange area for a riveted plate girder is to be designed considering net area as 80% of its gross area. Consider width of the flange as 500 mm while web plate as 1000 mm x 12 mm. The girder is to resist a maxi-mum BM of 4500 kNm. Maximum allowable bending stress in tension is 150 MPa. Gross flange area is....
MCQ->The following quantities refer to a channel section used as a beam : b = width of flange (upto centre of web thickness).h = depth of web (c/c of flange thickness). t = thickness of flange and web.I = moment of inertia of channel about xx axis.e = distance of shear centre, outside the channel from the mid thickness of the web.The value of 'e' is given by....
MCQ->When the depth of a plate girder is at least n times the depth of vertical leg of the flange angles, the girder is known as deep plate girder, if n is....
MCQ->Consider the following statements :1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area.2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum.3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum.Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions