1. The falling rate period in the drying of a solid is characterised by





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The economic condition in which the rate at which the general level of prices for goods and services is rising and subsequently; purchasing power is falling is called?....
QA->PIIGS is the group of nations falling under which zone?....
QA->Who is the author of the book " Falling Over Backward " ?....
QA->are based on the principle that the rate of water absorption is essentially equal to the rate of water loss?....
QA->Allbanks have now moved to a new lending rate regime—the marginal cost offunds-based lending rate (MCLR) starting....
MCQ->200 kg of solids (on dry basis) is subjected to a drying process for a period of 5000 seconds. The drying occurs in the constant rate period with the drying rate as, Nc = 0.5 x 10-3 kg/m2.s. The initial moisture content of the solid is 0.2 kg moisture/kg dry solid. The interfacial area available for drying is 4 m2/1000 kg of dry solid. The moisture content at the end of the drying period is (in kg moisture/kg dry solid)....
MCQ->A solid is being dried in the linear drying rate regime from moisture content Xo to XF. The drying rate is zero at X = 0 and the critical moisture content is the same as the initial moisture Xo. The drying time for M = (Ls/ARc) is (where, L = total mass of dry solid, A = total surface area for drying Rc = Constant maximum drying rate per unit area X = moisture content (in mass of water/mass of dry solids))....
MCQ->The drying time between fixed moisture content within diffusion controlled 'falling rate period' is proportional to (assuming that drying occurs from all surfaces of the solid) (where, T = thickness of the solid )....
MCQ->The falling rate period in the drying of a solid is characterised by....
MCQ->The drying time between fixed moisture contents within the 'constant rate period' is proportional to (assuming that drying occurs from all surfaces of the solid) (where, T = thickness of the solid )....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions