Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in
Multiple Choice Question in 049
Multiple Choice Question in 2016
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. Adiabatic flame temperature of a fuel is dependent on the initial temperature of
(A): fuel
(B): air
(C): both &
(D): neither nor
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->During adiabatic compression of a gas; what is the its temperature?....
QA->During adiabatic compression of a gas, what is the its temperature?....
QA->In a database design, if every non-key attribute is functionally dependent on the primary key, then the relation will be in :....
QA->Higher octane rating of a SI engine fuel indicates that the fuel has:....
QA->The Bulk modulus of elasticity in the case of an adiabatic expansion is :....
MCQ-> In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of the four alternatives.When the kerosene burned, the fuel in the tank below would be __________ pressure
, and __________ a small circular flame would appear in the burner. The valve had to be opened to let more kerosene vapour to the burner and pumping resumed. With the increase in pressure, the burner flame would spread _________ a loud noise. To lower the flame, the valve had to be_________ opened to reduce the pressure and then tightened until the desired flame size was achieved. _________ you wanted the flame to be bigger, you had to hit the piston again. Pump stoves are still in vogue.below would be __________ pressure
....
MCQ->Adiabatic flame temperature of a fuel is dependent on the initial temperature of....
MCQ->For the case of a fuel gas undergoing combustion with air, if the air/fuel ratio is increased, the adiabatic flame temperature will....
MCQ->Actual flame temperature is always lower than the adiabatic flame temperature, because there is....
MCQ->The maximum adiabatic flame temperature in air is __________ the maximum flame temperature in pure oxygen.....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions