1. In a dry packed bed, the pressure drop will be changed by increasing the flow rate as





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The difference between the total present value of a stream of cash flow of a given rate of discount and the initial capital outlay is known as :....
QA->Dry steam which is further heated at a constant pressure thus raising its temperature is called as:....
QA->The purpose of a radiator pressure cap is to maintain the working pressure of a water cooling system.....
QA->Which winds are flowing from sub tropical high pressure to sub polar low pressure?....
QA->Blood pressure is the pressure exerted on the wall of which part?....
MCQ->In a dry packed bed, the pressure drop will be changed by increasing the flow rate as....
MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....
MCQ->At the same gas flow rate, the pressure drop in a packed tower being irrigated with liquid __________ that in dry packed tower.....
MCQ->Bed pressure drop in an air fluidised bed of catalyst particles (ρp = 200 kg/m3, Dp = 0.05 cm) of 60 cm bed depth and bed porosity of 0.5 expressed in cm of water (manometer) is....
MCQ->A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun's equation for the above fluid-particle system (in SI units) is given below : Δ P/L = 375 x 103 VOM + 10.94 x 106 V2OM (SI units) If water is to be used as the fluidising medium, in actual operation, the above bed has a height = 1 m. What is the porosity of the fluidised bed ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions