Compressed dry air is used as the cutting fluid, while machining ?->(Show Answer!)

1. Compressed dry air is used as the cutting fluid, while machining

Write Comment

Comments

Tags

Show Similar Question And Answers

QA->The High Court of which state in India had given a verdit that all new vehicle registered in the State should run on Compressed Natural Gas (CNG)?....

QA->Which allotrope of the carbon is used in cutting and drilling?....

QA->First Woman Air Vice-Marshal and Air-Marshal in Indian Air Force....

QA->Vegetative propagation by stem cutting is generally foundation of which plant?....

QA->Which country is well known for diamond cutting industry?....

MCQ->Compressed dry air is used as the cutting fluid, while machining....

MCQ-> Read the following passage and answer the questions that follow. In calendar year 2008, there was turbulence in the air as Jet Airways' Chairman pondered what course of action the airline should take. Air India was also struggling with the same dilemma. Two of India's largest airlines, Air India and Jet Airways, had sounded caution on their fiscal health due to mounting operational costs. A daily operational loss of $2 million (Rs 8.6 crore) had in fact forced Jet Airways to put its employees on alert. Jet's senior General Manager had termed the situation as grave. Jet's current losses were $2 million a day (including Jet-Lite). The current rate of Jet Airways' domestic losses was $0.5 million (Rs 2.15 crore) and that of JetLite was another $0.5 million. International business was losing over $1 million (Rs 4.30 crore) a day. The situation was equally grave for other national carriers. Driven by mounting losses of almost Rs 10 crore a day. Air India, in its merged avatar, was considering severe cost cutting measures like slashing employee allowances, reducing In flight catering expenses on short haul flights and restructuring functional arms. The airline also considered other options like cutting maintenance costs by stationing officers at hubs, instead of allowing them to travel at regular intervals. Jet Airways, Air India and other domestic airlines had reasons to gel worried, as 24 airlines across the world had gone bankrupt in the year on account of rising fuel costs. In India, operating costs had gone up 30 - 40%. Fuel prices had doubled in the past one year to Rs 70,000 per kilolitre, forcing airlines to increase fares. Consequently, passenger load had fallen to an average 55-60% per flight from previous year's peak of 70-75%. Other airlines faced a similar situation; some were even looking for buyers. Domestic carriers had lost about Rs 4,000 crore in 2007-08 with Air India leading the pack. "As against 27% wage bill globally, our wage bill is 22% of total input costs. Even then we are at a loss," an Air India official said. Civil aviation ministry, however, had a different take. "Air India engineers go to Dubai every fortnight to work for 15 days and stay in five star hotels. If they are stationed there, the airline would save Rs 8 crore a year. This is just the tip of the iceberg. There are several things we can do to reduce operational inefficiency. " According to analysts, Jet Airways could be looking at a combined annual loss of around Rs 3,000 crore, if there were no improvement in operational efficiencies and ATF prices. Against this backdrop, the airline had asked its employees to raise the service bar and arrest falling passenger load.Which of the following are the reasons for Jet Airways not doing well? 1. Rising ATF prices 2. Reduced passenger load 3. Declining service quality 4. Staff travelling to Dubai....

MCQ->In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2.s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m2/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is....

MCQ->Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation ?A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent.D. Fluid is compressible.E. Fluid is incompressible.....

MCQ->At equilibrium the concentration of water in vapour phase (C)in kg/m3 of air space and the amount of water (m) adsorbed per kg of dry silica gel are related by, C = 0.0667m. To maintain dry conditions in a room of air space 100m3 containing 2.2 kg of water vapour initially, 10 kg of dry silica gel is kept in the room. The fraction of initial water remaining in the air space after a long time (during which the temperature is maintained constant) is....