1. In sheet metal forming, stretcher strains occur in





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A metal sheet with circular hole is heated. what change will be in the hole?....
QA->Meeting of beneficiaries for forming a beneficiary committee to take up and execute a public work is to be convened by:....
QA->Every promise and every set of promises forming consideration for each other is :....
QA->Which element helps in the fruit forming stage in plants?....
QA->The horizontal and vertical lines on a work sheet are called?....
MCQ->In sheet metal forming, stretcher strains occur in....
MCQ->Consider the given statement/s to be true and decide which of the given conclusions/assumptions can definitely be drawn from the given statement. Statements: Life means stresses and strains. Stresses and strains have an adverse effect on life. Conclusions: I. Life is not worth living. II. One should avoid stresses and strains in life.....
MCQ->Stretcher strains found in a low carbon sheet are associated with the....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Statements : (I) All the watches sold in that shop are made of white metal. (II) Some of Rico watches are sold in that shop. Inferences : 1. All watches of white metals are manufactured by Rico. 2. Some of Rico watches are of white metal. 3. None of Rico watches are of white metal. 4. Some of Rico watches of white metal are sold in that shop.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions