1. Reynolds (Rei) number for the impeller is given by (where Di, stirrer diameter; N, stirrer speed, ρ, density of fluid and μ, viscosity of fluid)





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A car during its journey travels 30 minutes at the speed of 40 km/hr. another 45 minutes at the speed of 60 km /hr and for two hours at a speed of 70 km/hr. Find the average speed of the car?....
QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....
QA->The instrument used for measuring the density or relative density of liquids?....
QA->RailwayMinistry and National High Speed Rail Corporation entered into a tripartiteagreement with this agency to develop Mumbai- Ahmedabad High Speed RailwayProject.....
QA->If the diameter of a circle is doubled, its area is increased by …… times.....
MCQ->Reynolds (Rei) number for the impeller is given by (where Di, stirrer diameter; N, stirrer speed, ρ, density of fluid and μ, viscosity of fluid)....
MCQ->For laminar flow, Reynolds number is correlated with power number as (where K, a constant which depends on the container geometry and shape of stirrer; Rei is Reynolds number for agitator; Di, stirrer diameter and N, stirrer speed)....
MCQ->For turbulent flow, Reynolds number is correlated with power number as (where K, a constant which depends on the container geometry and shape of stirrer; Rei, is Reynolds number for agitator; Di, stirrer diameter and N, stirrer speed)....
MCQ->At low Reynold's number, the power (P) required for agitating a fluid in a stirred tank becomes independent of inertial forces. In this limit, indicate which of the following relations is satisfied: Po = ρ/ρN3 D5 : Power number Re = ρ N D2/μ: Reynold's number N is the impeller rotational speed, and D is the impeller diameter.....
MCQ->For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions