1. If speed of dc motor increases with load torque, then it is a :





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The part of a torque converter that facilitates change of torque between input and output shaft is the:....
QA->A car during its journey travels 30 minutes at the speed of 40 km/hr. another 45 minutes at the speed of 60 km /hr and for two hours at a speed of 70 km/hr. Find the average speed of the car?....
QA->As per the motor vehicle act 1988, the maximum speed limit for motor cycle is :....
QA->India govt plan to construct new corridor for high speed train with speed range 300-350 kmph. What is the present maximum speed of long distance train in India?....
QA->Torque transfer at an angle is provided on propeller shaft by using :....
MCQ->A man travels by a motor boat down a river to his office and back. With the speed of the river unchanged, if he doubles the speed of his motor boat, then his total travel time gets reduced by 75%. The ratio of the original speed of the motor boat to the speed of the river is....
MCQ->Consider the following statements about variable reluctance stepper motor used in control system The static torque acting on rotor is a function of angular misalignment between stator and rotor teethThere are two positions of zero torque i.e, . Q = 0 and where T is the number of rotor teethBoth zero torque positions are stableWhen stator is excited, rotor is pulled into minimum reluctance position Of these statements, the correct ones are....
MCQ->A dc series motor is coupled to a load whose torque is proportional to speed. It is fed by a single phase ac supply through a full converter. When speed is 500 rpm, firing angle is 45°. It is desired to raise the speed. It will be necessary to....
MCQ->If speed of dc motor increases with load torque, then it is a :....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure :1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile.2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile.3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile.4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays.Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions