1. The depression formed at the end of the weld is named as :





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The process by which heat is transferred from the hotter end to the colder end of an object is known as ______ :....
QA->A program Graph has ‘start’ and ‘end’ nodes. The total number of paths from start to end is equivalent to the -----------set of test data required to test the software.....
QA->In a Program Graph, ‘X’ is an if-then-else node. If the number of paths from start node to X is ‘p’ number of paths from if part to end node is ‘q’ and from else part to end node is ’r’, the total number of possible paths through X is :....
QA->Former India all-rounder who has been named Afghanistan"s bowling coach until the end of the World T20 in India next year?....
QA->Who is the author of “The Great Depression of 1990”?....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The depression formed at the end of the weld is named as :....
MCQ-> DIRECTIONS for the following three questions: Answer the questions on the basis of the information given below.A city has two perfectly circular and concentric ring roads, the outer ring road (OR) being twice as long as the inner ring road (IR). There are also four (straight line) chord roads from E1, the east end point of OR to N2, the north end point of IR; from N1, the north end point of OR to W2, the west end point of IR; from W1, the west end point of OR, to S2, the south end point of IR; and from S1 the south end point of OR to E2, the east end point of IR. Traffic moves at a constant speed of $$30\pi$$ km/hr on the OR road, 20$$\pi$$ km/hr on the IR road, and 15$$\sqrt5$$ km/hr on all the chord roads.The ratio of the sum of the lengths of all chord roads to the length of the outer ring road is
 ....
MCQ->A circular plate 100 mm diameter is welded to another plate by means of 6 mm fillet weld. If the permissible shearing stress in the weld equals 10 kg/mm2, then the greatest twisting moment that can be resisted by the weld will be....
MCQ->The strength of single fillet weld,having length of weld 1,weld size s and permissible stresses is:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions