Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in
Multiple Choice Question in 049
Multiple Choice Question in 2016
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. Which one of the following is correct for Berger’s vector in screw dislocation?
(A): perpendicular to the dislocation line
(B): parallel to the dislocation line
(C): inclined to the dislocation line
(D): opposite to the dislocation line
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
kerala-psc
2016
WORKS-MANAGER---STATE-WATER-TRANSPORT
049/2016
049
Show Similar Question And Answers
QA->Who discovered Archimedean Screw ?....
QA->Archimedean Screw was invented by ?....
QA->The vector which can multiply in more than one host....
QA->The vector which can multiply in more than one host?....
QA->The vector which can multiply in more than one host-....
MCQ->Which one of the following is correct for Berger’s vector in screw dislocation?....
MCQ->The elastic strain energy of a unit length of an edge dislocation as compared to that of a screw dislocation is....
MCQ->In a simple screw jack, the pitch of the screw is 9 mm and length of the handle operating the screw is 45 cm. The velocity ratio of the system is....
MCQ->While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as....
MCQ->It is required to cut screw threads of 2 mm pitch on a lathe. The lead screw has a pitch of 6 mm. If the spindle speed is 60 r.p.m., then the speed of lead screw will be....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions