1. The angle of blow pipe to the line of weld in leftward welding technique is :





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Which are connected by over 1700 km-long BTC oil pipe-line?....
QA->Which are connected by over 1700 km-long BTC oil pipe-line ?....
QA->If the angle of intersection of a curve is φ., then deflection angle will be :....
QA->A liquid will not wet the surface of solid if the angle of contact is which angle?....
QA->Kerala Premo Pipe Factory Limited....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The angle of blow pipe to the line of weld in leftward welding technique is :....
MCQ->A tank has an inlet pipe and an outlet pipe. If the outlet pipe is closed then the inlet pipe fills the empty tank in 8 hours. If the outlet pipe is open then the inlet pipe fills the empty tank in 10 hours. If only the outlet pipe is open then in how many hours the full tank becomes half-full?....
MCQ->Two pipes A and B can fill an empty cistern in 4.8 and 7.2 hours, respectively. Pipe C can drain the entire cistern in 9.6 hours when no other pipe is in operation. Initially when the cistern was empty, Pipe A and Pipe C were turned on. After a few hours. Pipe A was turned off and Pipe B was turned on instantly. In all it took 16.8 hours to fill the cistern. For how many hours was Pipe B turned on?....
MCQ->Two pipes A and B can fill an empty cistern in 1.8 and 2.7 hours, respectively. Pipe C can drain the entire cistern in 4.5 hours when no other pipe is in operation. Initially when the cistern was empty Pipe A and Pipe C were turned on. After a few hours Pipe A was turned off and Pipe B was turned on instantly. In all it took 5.5 hours to fill the cistern. For how many hours was Pipe B turned on?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions