1. Applying metal coating using zinc in an iron material is known as





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->The process of coating iron or steel with zinc for protection against corrosion is called _____ :....
QA->Galvanised iron sheets have a coating of which metal?....
QA->Galvanized iron is coated with a thin coating of:....
QA->Galvanized iron is coated with a thin coating of....
QA->A car which runs along a straight level road at a speed of 36km/hour is brought to rest in 2 seconds by applying the brakes. The stopping distance is :....
MCQ->Which of the following methods is suitable for preventing an iron frying pan from rusting? I. Applying grease II. Applying paint III. Applying a coating of zinc IV. All of these ....
MCQ->Applying metal coating using zinc in an iron material is known as....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Protection of ship hulls against sea water corrosion is done by coating with zinc because of the fact that zinc compared to iron is....
MCQ->In an alloy of German silver. the ratio of copper to zinc was 21 : 16 while that of nickel to zinc was 7 : 24. What was the ratio of copper to zinc to nickel in the alloy?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions