1. Two mating spur gears have 40 and 120 teeth respectively. The pinion rotates at 900 rpm and transmits a torque of 25 Nm. The torque transmitted by the gear is :





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A sliding mesh gearbox has a gear ratio 4:1 at the third gear position. The clutch shaft gear has 15 teeth and its mating lay shaft gear is having 45 teeth. If the main shaft gear contains 28 teeth, the mating lay shaft gear should have:....
QA->The part of a torque converter that facilitates change of torque between input and output shaft is the:....
QA->A school has only three classes comprised of 40, 50 and 60 students respectively. In these classes, 10%, 20% and 10% students respectively passed in the examinations. What is the percentage of students passed in the examination from the entire school?....
QA->The type of gears used for transmitting power between two-non intersecting perpendicular shafts is :....
QA->The Earth rotates-around an axis pointing towards which side?....
MCQ->Two mating spur gears have 40 and 120 teeth respectively.The pinion rotates at 900 rpm and transmits a torque of 25 Nm.The torque transmitted by the gear is:....
MCQ->Two mating spur gears have 40 and 120 teeth respectively. The pinion rotates at 900 rpm and transmits a torque of 25 Nm. The torque transmitted by the gear is :....
MCQ->A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is....
MCQ->The following data refers to two crossed helical gears used for speed reduction. Gear I: Pitch circle diameter in the plane of rotation 80 mm and helix angle 30°. Gear II: Pitch circle diameter in the plane of rotation 120 mm and helix angle 22.5°. If the input speed is 1280 rpm, the output speed in rpm is :....
MCQ->The following data refers to two crossed helical gears used for speed reduction. Gear 1 Pitchcircle diameter in the plane of rotation 80 mm and helix angle 30o .Gear II. Pitch circle diameter in the plane of rotation 120 mm and helix angle 22.5°, It the input speed is 1280 rpm, the output speed in rpm is :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions