Which of the following works as a powerful barrier against vertical mobility in India? ?->(Show Answer!)

1. Which of the following works as a powerful barrier against vertical mobility in India?

Write Comment

Comments

Tags

Show Similar Question And Answers

QA->A groupof scientists recently revealed that the Great Barrier Reef suffered from itsworst coral die-off ever recorded. Where is the Great Barrier Reef located?....

QA->The 2016Urban Mobility India conference has started in which state?....

QA->Which of the companies has launched awide range of electric mobility vehicles in India recently?....

QA->The mobility solutions company, letsgomo, has been acquired by which Indian e-commerce company?....

QA->Which type of rainfall that occurs when wind rises up along a hill or mountain barrier?....

MCQ-> Study the following information carefully and answer the questions given below: Eight persons S, T, U, V, W, X, Y and Z live on eight different floors of a building but not necessarily in the same order. The lowermost floor of the building is numbered one, the one above that is numbered two and so one till the topmost floor is numbered eight. Each of them also works at a different banks namely, IDBI, SBI, HDFC, BOI, PNB, TJSB, Axis Bank and SVC, but not necessarily in the same order. • Z lives on an even numbered floor. Only three persons live between Z and the one who orks at BOI. W lives immediately below the one who works at BOI. • Only three persons live between W and the one who works at Axis Bank. • V lives immediately above T. V lives on an odd numbered floor. T does not work at BOI. • Only two persons live between T and the one who works at SBI. The one who works at SBI does not live on the lowermost floor. • The one who works at SVC lives immediately above the one who works at PNB. The one who works at SVC live on an even numbered floor but not on floor numbered two. • Only one person lives between the one who works at SVC and the one who works at IDBI. • X lives immediately above S. X lives on an even numbered floor. X does not work at TJSB. • U does not work at PNB and does not live on floor numbered four.Four of the following five are alike in a certain way based on the given arrangement and hence they form a group. Which one of the following does not belong to that group?
....

MCQ->Which of the following works as a powerful barrier against vertical mobility in India?....

MCQ-> Read the following information and answer the given questions. (I) Six friends Ramesh, Dinesh, Lokesh, Nilesh, Shailesh and Hitesh work in different companies namely ‘P’, ‘Q’, ’R’, ‘S’, ‘T’, and ‘U’, and each one wears company sponsored different coloured tie, i.e., Blue, Green, Pink, Yellow, Purple and Red though not necessarily in the same order. (II) The one wearing Blue tie works in company ‘S’ and the one wearing Green tie works in company ‘P’. (III) Hitesh does not work in company ‘R’ or ‘T’. (IV) Ramesh wears Pink tie and works in company ‘Q’. (V) Nilesh does not work in company ‘T’ and Purple colour tie is not sponsored by company ‘R’. (VI) Shailesh works in company ‘U’ and neither Nilesh nor Dinesh works in company ‘S’. (VII) Company ‘T’ does not sponsor Purple or Yellow coloured tie and Lokesh works in company P.Which colour is sponsored by Company ‘R’ ?
....

MCQ-> Study the following information and answer the given questions. Seven people namely D, E, F, G, H, I and J like seven different monuments namely, Taj Mahal, Red Fort, Charminar, India Gate, Qutub Minar, Victoria Memorial and Sanchi Stupa. Each of them work in either of the three fields viz. Economics, Management and Pharmacy with atleast two of them in a field. (Note: None of the information given is necessarily in the same order.) The one who likes Qutub Minar works in field of Management only with G. The one who likes Charminar works with the one who likes Sanchi Stupa. J works with the one who likes India Gate. I neither works with G nor in the field of Pharmacy. J does not like Charminar. D likes Red Fort. D does not work with J. F work with only one person. F does not like Qutub Minar. H works with I. I does not like Charminar. Neither G nor F likes Taj Mahal.Which of the following combinations represents the combination of people who work in the field of Economics ?
....

MCQ-> In a modern computer, electronic and magnetic storage technologies play complementary roles. Electronic memory chips are fast but volatile (their contents are lost when the computer is unplugged). Magnetic tapes and hard disks are slower, but have the advantage that they are non-volatile, so that they can be used to store software and documents even when the power is off.In laboratories around the world, however, researchers are hoping to achieve the best of both worlds. They are trying to build magnetic memory chips that could be used in place of today’s electronics. These magnetic memories would be nonvolatile; but they would also he faster, would consume less power, and would be able to stand up to hazardous environments more easily. Such chips would have obvious applications in storage cards for digital cameras and music- players; they would enable handheld and laptop computers to boot up more quickly and to operate for longer; they would allow desktop computers to run faster; they would doubtless have military and space-faring advantages too. But although the theory behind them looks solid, there are tricky practical problems and need to be overcome.Two different approaches, based on different magnetic phenomena, are being pursued. The first, being investigated by Gary Prinz and his colleagues at the Naval Research Laboratory (NRL) in Washington, D.c), exploits the fact that the electrical resistance of some materials changes in the presence of magnetic field— a phenomenon known as magneto- resistance. For some multi-layered materials this effect is particularly powerful and is, accordingly, called “giant” magneto-resistance (GMR). Since 1997, the exploitation of GMR has made cheap multi-gigabyte hard disks commonplace. The magnetic orientations of the magnetised spots on the surface of a spinning disk are detected by measuring the changes they induce in the resistance of a tiny sensor. This technique is so sensitive that it means the spots can be made smaller and packed closer together than was previously possible, thus increasing the capacity and reducing the size and cost of a disk drive. Dr. Prinz and his colleagues are now exploiting the same phenomenon on the surface of memory chips, rather spinning disks. In a conventional memory chip, each binary digit (bit) of data is represented using a capacitor-reservoir of electrical charge that is either empty or fill -to represent a zero or a one. In the NRL’s magnetic design, by contrast, each bit is stored in a magnetic element in the form of a vertical pillar of magnetisable material. A matrix of wires passing above and below the elements allows each to be magnetised, either clockwise or anti-clockwise, to represent zero or one. Another set of wires allows current to pass through any particular element. By measuring an element’s resistance you can determine its magnetic orientation, and hence whether it is storing a zero or a one. Since the elements retain their magnetic orientation even when the power is off, the result is non-volatile memory. Unlike the elements of an electronic memory, a magnetic memory’s elements are not easily disrupted by radiation. And compared with electronic memories, whose capacitors need constant topping up, magnetic memories are simpler and consume less power. The NRL researchers plan to commercialise their device through a company called Non-V olatile Electronics, which recently began work on the necessary processing and fabrication techniques. But it will be some years before the first chips roll off the production line.Most attention in the field in focused on an alternative approach based on magnetic tunnel-junctions (MTJs), which are being investigated by researchers at chipmakers such as IBM, Motorola, Siemens and Hewlett-Packard. IBM’s research team, led by Stuart Parkin, has already created a 500-element working prototype that operates at 20 times the speed of conventional memory chips and consumes 1% of the power. Each element consists of a sandwich of two layers of magnetisable material separated by a barrier of aluminium oxide just four or five atoms thick. The polarisation of lower magnetisable layer is fixed in one direction, but that of the upper layer can be set (again, by passing a current through a matrix of control wires) either to the left or to the right, to store a zero or a one. The polarisations of the two layers are then either the same or opposite directions.Although the aluminum-oxide barrier is an electrical insulator, it is so thin that electrons are able to jump across it via a quantum-mechanical effect called tunnelling. It turns out that such tunnelling is easier when the two magnetic layers are polarised in the same direction than when they are polarised in opposite directions. So, by measuring the current that flows through the sandwich, it is possible to determine the alignment of the topmost layer, and hence whether it is storing a zero or a one.To build a full-scale memory chip based on MTJs is, however, no easy matter. According to Paulo Freitas, an expert on chip manufacturing at the Technical University of Lisbon, magnetic memory elements will have to become far smaller and more reliable than current prototypes if they are to compete with electronic memory. At the same time, they will have to be sensitive enough to respond when the appropriate wires in the control matrix are switched on, but not so sensitive that they respond when a neighbouring elements is changed. Despite these difficulties, the general consensus is that MTJs are the more promising ideas. Dr. Parkin says his group evaluated the GMR approach and decided not to pursue it, despite the fact that IBM pioneered GMR in hard disks. Dr. Prinz, however, contends that his plan will eventually offer higher storage densities and lower production costs.Not content with shaking up the multi-billion-dollar market for computer memory, some researchers have even more ambitious plans for magnetic computing. In a paper published last month in Science, Russell Cowburn and Mark Well and of Cambridge University outlined research that could form the basis of a magnetic microprocessor — a chip capable of manipulating (rather than merely storing) information magnetically. In place of conducting wires, a magnetic processor would have rows of magnetic dots, each of which could be polarised in one of two directions. Individual bits of information would travel down the rows as magnetic pulses, changing the orientation of the dots as they went. Dr. Cowbum and Dr. Welland have demonstrated how a logic gate (the basic element of a microprocessor) could work in such a scheme. In their experiment, they fed a signal in at one end of the chain of dots and used a second signal to control whether it propagated along the chain.It is, admittedly, a long way from a single logic gate to a full microprocessor, but this was true also when the transistor was first invented. Dr. Cowburn, who is now searching for backers to help commercialise the technology, says he believes it will be at least ten years before the first magnetic microprocessor is constructed. But other researchers in the field agree that such a chip, is the next logical step. Dr. Prinz says that once magnetic memory is sorted out “the target is to go after the logic circuits.” Whether all-magnetic computers will ever be able to compete with other contenders that are jostling to knock electronics off its perch — such as optical, biological and quantum computing — remains to be seen. Dr. Cowburn suggests that the future lies with hybrid machines that use different technologies. But computing with magnetism evidently has an attraction all its own.In developing magnetic memory chips to replace the electronic ones, two alternative research paths are being pursued. These are approaches based on:
....