Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in 049
Multiple Choice Question in
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in 2016
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Question Answer Bank
1. Synonym of Rotation (n)
Answer: revolution; orbit; cycle
Previous Question
Next Question
Add Tags
Report Error
Reply
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->Tyre rotation is a recommended method to equalize the tyre wear. In doing the tyre rotation, generally, the spare wheel will be fitted to the :....
QA->Synonym of Rotation (n)....
QA->The Time taken by the Earth to complete the rotation is....
QA->The annual variation of magnetic declination at a place is caused because of the rotation of :....
QA->HOW MUCH TIME DOES A GEO-STATIONARY SATELLITE TAKES TO COMPLETE ONE ROTATION AROUND EARTH....
MCQ->The combined motion of rotation and translation may be assumed to be a motion of pure rotation about some centre which goes on changing from time to time. The centre in question is known as...
MCQ->A circular shaft fixed at, A has diameter D for half of its length and diameter D/2 over the other half, as shown in the below figure. If the rotation of B relative to A is 0.1 radian, the rotation of C relative to B will be...
MCQ->A disturbing mass m1 attached to the rotating shaft may be balanced by a single mass m2 attached in the same plane of rotation as that of m1, such that (where r1 and r2 are the radii of rotation of m1 and m2 respectively)...
MCQ->The following data refers to two crossed helical gears used for speed reduction. Gear I: Pitch circle diameter in the plane of rotation 80 mm and helix angle 30°. Gear II: Pitch circle diameter in the plane of rotation 120 mm and helix angle 22.5°. If the input speed is 1280 rpm, the output speed in rpm is :...
MCQ->The following data refers to two crossed helical gears used for speed reduction. Gear 1 Pitchcircle diameter in the plane of rotation 80 mm and helix angle 30o .Gear II. Pitch circle diameter in the plane of rotation 120 mm and helix angle 22.5°, It the input speed is 1280 rpm, the output speed in rpm is :...
×
×
Type The Issue
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions