<<= Back Next =>>
You Are On Multi Choice Question Bank SET 1220

61001. Assume you want to determine the timing diagram for a 4-bit counter using an oscilloscope. The best choice for an oscilloscope trigger signal is ________.





61002. --------is the document issued by the Court directing a person to appear before a Court





61003. Referring to the function table given below, taking the CLEAR, S1, and S0 inputs all HIGH ________.





61004. The year of payment of Bonus Act:





61005. Assume a 4-bit ripple counter has a failure in the second flip-flop such that it "locks up." The third and fourth stages will ________.





61006. ---------is filling a petition by the aggrieved party before a higher authority.





61007. In order to use a shift register as a counter, ________.




61008. -------------is an economic remedy for economical adjustment.





61009. In order to check the CLR function of a counter, ________.





61010. The book of original entry in Co-operative Society is:





61011. The circuit shown below is used for ________, and for the inputs shown, the DATA output will be ________.





61012. ”Each For All”or”All for Each”is -------------of operation.





61013. ________ is the output frequency of the counter shown below.





61014. The first Co-operative Society in:





61015. An asynchronous binary up counter, made from a series of leading edge-triggered flip-flops, can be changed to a down counter by ________.





61016. ---------is the first Co-operative model in the worl





61017. A 4-bit binary up counter has an input clock frequency of 20 kHz. The frequency of the most significant bit is ________.





61018. UNICOOP was established in 1961 by:





61019. Modulus refers to ________.





61020. The area of Central Co-0perative Bank is:





61021. NCDC was established in:





61022. AMUL is for:





61023. A sequential circuit design is used to ________.





61024. Create Co-operators before creating Co-operatives pointed out by-----------committee.





61025. The MOD-10 counter is also referred to as a ________ counter.





61026. Co-operative Principles were formulated by----------conference





61027. In general, when using a scope to troubleshoot digital systems the instrument should be triggered by ________.





61028. World food day on:





61029. ________ counters are often used whenever pulses are to be counted and the results displayed in decimal.





61030. Co-operation has failed but it most succeed expressed by:





61031. The technique used by one-shots to respond to an edge rather than a level is called ________.





61032. Se43 of the IPC deals with





61033. A J-K flip-flop is reset and must stay reset after the clock pulse. This transition requires that ________.



61034. Occupies an important position in the democratic setup of the society





61035. ________ is the modulus of the counter shown below.





61036. Sec-provides that a society are exempted from stamp duty.





61037. The ________ counter in the Altera library has controls that allow it to count up or down, and perform synchronous parallel load and asynchronous cascading.





61038. From-statement the Society prepared the fiani accounts.





61039. A BCD counter has ________ states.





61040. Subjudice means:





61041. The decimal equivalent of the largest number that can be stored in a 4-bit binary counter is ________.





61042. The minimum number of flip-flops that can be used to construct a modulus-5 counter is ________.





61043. The duty cycle of the most significant bit from a 4-bit (0–9) BCD counter is ________.





61044. Shift-register counters use ________, which means that the output of the last FF in the register is connected back to the first FF in some way.





61045. The counter circuit and associated waveforms shown below are for a(n) ________ counter, and the correct output waveform for QB is shown by waveform ________.





61046. Asynchronous counters are often called ________ counters.





61047. The given circuit is a(n) ________.





61048. How many flip-flops are required to make a MOD-32 binary counter?





61049. Using four cascaded counters with a total of 16 bits, how many states must be deleted to achieve a modulus of 50,000?





61050. A MOD-16 ripple counter is holding the count 10012. What will the count be after 31 clock pulses?





<<= Back Next =>>
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions