1. If the area of a metal wire of a given length is doubled,its resistance will be:





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Specific resistance of a wire varies with:....
QA->If the diameter of a circle is doubled, its area is increased by …… times.....
QA->If the mass of the pendulum is doubled; what will its the time period?....
QA->If the mass of the pendulum is doubled, what will its the time period?....
QA->Which is the planet its length of its day and the tilt of its axis are almost identical to those of the earth?....
MCQ->A metal wire of length l and area of cross section A is subjected to a longitudinal force Mg. The wire elongates by a length l. If the Youngs Modulus of the material of the wire is Y, the work done by the external force is:....
MCQ->A wire has a resistance R ohm. If another wire of the same material and same weight has double the diameter (as compared to the first wire), the resistance of the second wire will be....
MCQ->If the area of a metal wire of a given length is doubled,its resistance will be:....
MCQ->If the area of a metal wire of a given length is doubled, its resistance will be :....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions