1. The moment of inertia of a solid cylinder of mass m, radius r and length l about the longitudinal axis or polar axis is





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->If the radius of a cylinder is doubled and the height is halved, what is the ratio between the new volume and previous volume?....
QA->A loose fit between a dry cylinder liner and cylinder block would cause:....
QA->Cylinder block construction by mono-block is preferred to individual cylinder construction because of?....
QA->Which is not an advantage of multi cylinder air cooled engines when compared to multi cylinder water cooled engines?....
QA->In case of offset pistons, the piston pin hole axis is made offset from the cylinder centerline towards the :....
MCQ->The moment of inertia of a solid cylinder of mass m, radius r and length l about the longitudinal axis or polar axis is....
MCQ->What is the volume of the cylinder (in cubic metre)? (I) The sum of height and radius of the cylinder is 24m. The total surface area of the cylinder is 2112 sq. m. (II) LCM and HCF of the numerical values of the radius and height of the cylinder are 70 and 2 respectively. The square of numerical values of the radius of the cylinder is 96 more than the square of the numerical value of the height of the cylinder.....
MCQ->A metallic solid is made up of a solid cylindrical base with a solid cone on its top. The radius of the base of the cone is 5 cm. and the ratio of the height of the cylinder and the cone is 3:2. A cylindrical hole is drilled through the solid with height equal to 2/$$3^{rd}$$ of the height of solid. What should be the radius (in cm) of the hole so that the volume of the hole is 1/$$3^{rd}$$ of the volume of the metallic solid after drilling?....
MCQ->According to parallel axis theorem, the moment of inertia of a section about an axis parallel to the axis through centre of gravity (i.e. IP) is given by(where, A = Area of the section, IG = Moment of inertia of the section about an axis passing through its C.G., and h = Distance between C.G. and the parallel axis.)....
MCQ->In order to have a connecting rod equally strong in buckling about X-axis and Y-axis, the moment of inertia about X-axis should be __________ the moment of inertia about Y-axis.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions