1. The material generally used for cylinder sleeves is





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Cylinder block construction by mono-block is preferred to individual cylinder construction because of?....
QA->A loose fit between a dry cylinder liner and cylinder block would cause:....
QA->Which is not an advantage of multi cylinder air cooled engines when compared to multi cylinder water cooled engines?....
QA->Idiom of 12. Laugh in one's sleeves....
QA->Idiom of 270. To laugh in one's sleeves....
MCQ->What is the volume of the cylinder (in cubic metre)? (I) The sum of height and radius of the cylinder is 24m. The total surface area of the cylinder is 2112 sq. m. (II) LCM and HCF of the numerical values of the radius and height of the cylinder are 70 and 2 respectively. The square of numerical values of the radius of the cylinder is 96 more than the square of the numerical value of the height of the cylinder.....
MCQ->The material generally used for cylinder sleeves is....
MCQ->If p1, is the pressure of air entering the L.P. cylinder and p2 is the pressure of air leaving the L.P. cylinder (or intercooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D1 = Dia. of L.P. cylinder, and D2 = Dia. of H.P. cylinder)....
MCQ->A long cylinder and a sphere both of 5 cms diameter are made from the same porous material. The flat ends of cylinder are sealed. Both the cylinder and sphere are saturated with the same solution of sodium chloride. Later both the objects are immersed for a short and equal interval of time in a large tank of water which is well agitated. The fraction of salt remaining in the cylinder and the sphere are Xc and Xs respectively. Which of the following statement is correct ?....
MCQ->The estimated material cost given in the table titled “Variable Cost Estimates of Mulchand Textiles” included the cost of material that gets spoiled in the production process. Mr. Sharma decomposed the estimated material cost into material spoilage cost and material usage cost, but he lost the data when his computer crashed. When he saw the following line diagram, here called that he measured the estimate of material spoilage cost per square feet of output on the y - axis and monthly output on the x - axis. Estimated material usage cost per square feet of output.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions