1. The basic characteristics of a brake fluid is





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->In an air brake system when the brake pedal is freed to deactivate the brakes, the high pressure air form the lines is released to the atmosphere through the :....
QA->Long treeless grassy palms are characteristics of which grass?....
QA->Which is the chief characteristics of wet and dry tropics?....
QA->The term clutch slip as applied to a fluid fly wheel:....
QA->Who discovered Molecular Scattering of light in fluid ?....
MCQ-> Study the information given below and answer the questions.The following table contains the pre and post revision pay structure of a Government departmentThe revision has been done based on the following terms: -In pre-revised pay scale, the basic pay is the sum of the minimum pay in the appropriate pay scale and the admissible increment. After revision, the basic pay is the sum of minimum pay in the appropriate pay scale and the respective grade pay and the admissible increments. -Annual increment of 3% of the basic pay (on a compounded basic) is paid under the revised pay rules. -Monthly Dearness Allowance (DA) is calculated as percentage of basic pay. -In pre-revised pay scales, the increment was given after the completion of each year of service, but, after revision annual increments are given only in the month of July every year and there should be a gap of six months between the increments. The employees who had joined the department in the month of September, October, November and December are given an increment at the time of revised pay fixation in September, 2008. The revised pay is applicable from 1st September, 2008.Abhijit joins the department on November 10, 2006 in the pay scale of Rs. 18,400-500-22,400 with the pay of Rs. 18,400 plus 2 increments. What is his basic salary, after revision, on August 1, 2009?
 ....
MCQ->Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation ?A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent.D. Fluid is compressible.E. Fluid is incompressible.....
MCQ->The brake power (B.P.) of the engine is given by (where W = Brake load or dead load in newtons, l = Length of arm in metres, N = Speed of engine in r.p.m., S - Spring balance reading in newtons, D = Dia. of brake drum in metres, and d = Dia. of rope in metres)....
MCQ->When the frictional force helps to apply the brake, then the brake is said to be self-energizing brake.....
MCQ->The basic characteristics of a brake fluid is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions