1. The impulse response and the excitation function of a linear time invariant causal system are shown in figure (a) and (b) respectively. The output of the system at t = 2 sec is equal to



Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Not a Bernstein’s condition for two processes P1 and P2 executing in parallel on input set I1 and I2, producing output set 0 1 and 0 2 respectively.....
QA->The linear formula for I/O seek time, with n tracks and startup time s, where m is a constant depends on disk drive:....
QA->A school has only three classes comprised of 40, 50 and 60 students respectively. In these classes, 10%, 20% and 10% students respectively passed in the examinations. What is the percentage of students passed in the examination from the entire school?....
QA->Who discovered the causal organism of the disease Anthrax?....
QA->On November 30, 2014, the Simon Wiesenthal Center reported that a senior Nazi figure who centrally involved in the implementation of the Holocaust had died in Syria around 2010, or four years earlier. Who is that Nazi figure?....
MCQ->The impulse response and the excitation function of a linear time invariant causal system are shown in figure (a) and (b) respectively. The output of the system at t = 2 sec is equal to....
MCQ->A linear time-invariant, causal continuous time system has a rational transfer function with simple poles at s = - 2 and s = - 4, and one simple zero at s = - 1. A unit step u(t) is applied at the input of the system. At steady state, the output has constant value of 1. The impulse response of this system is....
MCQ->The transfer function of a discrete time LTI system is given byConsider the following statements:S1: The system is stable and causal for ROC: |z| > 1/2S2: The system is stable but not causal for ROC: |z| < 1/4S3: The system is neither stable nor causal for ROC: 1/4 < |z| < 1/2Which one of the following statements is valid?....
MCQ->The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is....
MCQ->Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions