The total resistance in the given circuit can be found using the formula: RT = R1 + R2 || R3 || R4.p> ?->(Show Answer!)

1. The total resistance in the given circuit can be found using the formula: RT = R1 + R2 || R3 || R4.

Write Comment

Comments

Tags

Show Similar Question And Answers

QA->At the time of short-circuit; what will be the current in the circuit?....

QA->At the time of short-circuit, what will be the current in the circuit?....

QA->WHAT IS THE NAME OF INSTRUMENT THAT REGULATES THE RESISTANCE OF CURRENT IN A CIRCUIT....

QA->Cache performance can be measured in terms of average access time using the formula:....

QA->What can be considered as basic building blocks of a digital circuit?....

MCQ-> Answer questions on the basis of information given in the following case. MBA entrance examination comprises two types of problems: formula - based problems and application - based problem. From the analysis of past data, Interesting School of Management (ISM) observes that students good at solving application - based problems are entrepreneurial in nature. Coaching institutes for MBA entrance exams train them to spot formula - based problems and answer them correctly, so as to obtain the required overall cut - off percentile. Thus students, in general, shy away from application - based problem and even those with entrepreneurial mind - set target formula - based problems. Half of a mark is deducted for every wrong answer.ISM wants more students with entrepreneurial mind - set in the next batch. To achieve this, ISM is considering following proposals: I. Preparing a question paper of two parts, Parts A and Part B of duration of one hour each. Part A and Part B would consist of formula - based problems and application - based problems, respectively. After taking away Part A, Part B would be distributed. The qualifying cut - off percentile would be calculated on the combined scores of two parts. II. Preparing a question paper comprising Part A and Part B. While Part A would comprise formula - based problems, Part B would comprise application - based problems, each having a separate qualifying cut - off percentile. III. Assigning one mark for formula - based problems and two marks for application based problems as an incentive for attempting application - based problems. IV. Allotting one mark for formula - based problems and three marks for application - based problem, without mentioning this is the question paper. Which of the following proposal (or combination of proposals) is likely to identify students with best entrepreneurial mind - set?....

MCQ-> In a modern computer, electronic and magnetic storage technologies play complementary roles. Electronic memory chips are fast but volatile (their contents are lost when the computer is unplugged). Magnetic tapes and hard disks are slower, but have the advantage that they are non-volatile, so that they can be used to store software and documents even when the power is off.In laboratories around the world, however, researchers are hoping to achieve the best of both worlds. They are trying to build magnetic memory chips that could be used in place of today’s electronics. These magnetic memories would be nonvolatile; but they would also he faster, would consume less power, and would be able to stand up to hazardous environments more easily. Such chips would have obvious applications in storage cards for digital cameras and music- players; they would enable handheld and laptop computers to boot up more quickly and to operate for longer; they would allow desktop computers to run faster; they would doubtless have military and space-faring advantages too. But although the theory behind them looks solid, there are tricky practical problems and need to be overcome.Two different approaches, based on different magnetic phenomena, are being pursued. The first, being investigated by Gary Prinz and his colleagues at the Naval Research Laboratory (NRL) in Washington, D.c), exploits the fact that the electrical resistance of some materials changes in the presence of magnetic field— a phenomenon known as magneto- resistance. For some multi-layered materials this effect is particularly powerful and is, accordingly, called “giant” magneto-resistance (GMR). Since 1997, the exploitation of GMR has made cheap multi-gigabyte hard disks commonplace. The magnetic orientations of the magnetised spots on the surface of a spinning disk are detected by measuring the changes they induce in the resistance of a tiny sensor. This technique is so sensitive that it means the spots can be made smaller and packed closer together than was previously possible, thus increasing the capacity and reducing the size and cost of a disk drive. Dr. Prinz and his colleagues are now exploiting the same phenomenon on the surface of memory chips, rather spinning disks. In a conventional memory chip, each binary digit (bit) of data is represented using a capacitor-reservoir of electrical charge that is either empty or fill -to represent a zero or a one. In the NRL’s magnetic design, by contrast, each bit is stored in a magnetic element in the form of a vertical pillar of magnetisable material. A matrix of wires passing above and below the elements allows each to be magnetised, either clockwise or anti-clockwise, to represent zero or one. Another set of wires allows current to pass through any particular element. By measuring an element’s resistance you can determine its magnetic orientation, and hence whether it is storing a zero or a one. Since the elements retain their magnetic orientation even when the power is off, the result is non-volatile memory. Unlike the elements of an electronic memory, a magnetic memory’s elements are not easily disrupted by radiation. And compared with electronic memories, whose capacitors need constant topping up, magnetic memories are simpler and consume less power. The NRL researchers plan to commercialise their device through a company called Non-V olatile Electronics, which recently began work on the necessary processing and fabrication techniques. But it will be some years before the first chips roll off the production line.Most attention in the field in focused on an alternative approach based on magnetic tunnel-junctions (MTJs), which are being investigated by researchers at chipmakers such as IBM, Motorola, Siemens and Hewlett-Packard. IBM’s research team, led by Stuart Parkin, has already created a 500-element working prototype that operates at 20 times the speed of conventional memory chips and consumes 1% of the power. Each element consists of a sandwich of two layers of magnetisable material separated by a barrier of aluminium oxide just four or five atoms thick. The polarisation of lower magnetisable layer is fixed in one direction, but that of the upper layer can be set (again, by passing a current through a matrix of control wires) either to the left or to the right, to store a zero or a one. The polarisations of the two layers are then either the same or opposite directions.Although the aluminum-oxide barrier is an electrical insulator, it is so thin that electrons are able to jump across it via a quantum-mechanical effect called tunnelling. It turns out that such tunnelling is easier when the two magnetic layers are polarised in the same direction than when they are polarised in opposite directions. So, by measuring the current that flows through the sandwich, it is possible to determine the alignment of the topmost layer, and hence whether it is storing a zero or a one.To build a full-scale memory chip based on MTJs is, however, no easy matter. According to Paulo Freitas, an expert on chip manufacturing at the Technical University of Lisbon, magnetic memory elements will have to become far smaller and more reliable than current prototypes if they are to compete with electronic memory. At the same time, they will have to be sensitive enough to respond when the appropriate wires in the control matrix are switched on, but not so sensitive that they respond when a neighbouring elements is changed. Despite these difficulties, the general consensus is that MTJs are the more promising ideas. Dr. Parkin says his group evaluated the GMR approach and decided not to pursue it, despite the fact that IBM pioneered GMR in hard disks. Dr. Prinz, however, contends that his plan will eventually offer higher storage densities and lower production costs.Not content with shaking up the multi-billion-dollar market for computer memory, some researchers have even more ambitious plans for magnetic computing. In a paper published last month in Science, Russell Cowburn and Mark Well and of Cambridge University outlined research that could form the basis of a magnetic microprocessor — a chip capable of manipulating (rather than merely storing) information magnetically. In place of conducting wires, a magnetic processor would have rows of magnetic dots, each of which could be polarised in one of two directions. Individual bits of information would travel down the rows as magnetic pulses, changing the orientation of the dots as they went. Dr. Cowbum and Dr. Welland have demonstrated how a logic gate (the basic element of a microprocessor) could work in such a scheme. In their experiment, they fed a signal in at one end of the chain of dots and used a second signal to control whether it propagated along the chain.It is, admittedly, a long way from a single logic gate to a full microprocessor, but this was true also when the transistor was first invented. Dr. Cowburn, who is now searching for backers to help commercialise the technology, says he believes it will be at least ten years before the first magnetic microprocessor is constructed. But other researchers in the field agree that such a chip, is the next logical step. Dr. Prinz says that once magnetic memory is sorted out “the target is to go after the logic circuits.” Whether all-magnetic computers will ever be able to compete with other contenders that are jostling to knock electronics off its perch — such as optical, biological and quantum computing — remains to be seen. Dr. Cowburn suggests that the future lies with hybrid machines that use different technologies. But computing with magnetism evidently has an attraction all its own.In developing magnetic memory chips to replace the electronic ones, two alternative research paths are being pursued. These are approaches based on:
....

MCQ->The total resistance in the given circuit can be found using the formula: RT = R1 + R2 || R3 || R4.

....

MCQ-> Read the following passage and answer the questions. Passage: A new paper published by Rochman and her colleagues in February, in the journal Ecology, sifts through past research on marine debris to assess the true extent of the environmental threat. Plenty of studies have sounded alarm bells about the state of marine debris: Rochman and her colleagues set out to determine how many of those perceived risks are real Often. Rochman says, scientists will wrap up a paper by speculating about the broader impacts of what they've found. Maybe their study has shown that certain seabirds eat plastic bags, for example, and the paper goes on to warn that whole bird populations are at risk of dying out. "But the truth was that nobody had yet tested those perceived threats." Rochman says. "There wasn't a lot of information." Rochman and her colleagues examined more than a hundred papers on the impacts of marine debris that were published through 2013. Within each paper. they asked what threats scientists had studied-366 perceived threats in all and what they'd actually found. In 83 percent of cases, the perceived dangers of ocean trash were proven true. In most of the remaining cases. the working group found the studies too shoddy to draw conclusions from—they lacked a control group, for example. or used faulty statistics. Strikingly. Rochman says, only one well-designed study failed to find the effect it was looking for, an investigation of mussels ingesting microscopic plastic bits. The plastic moved from the mussels' stomachs to their bloodstreams. scientists found. and stayed there for weeks—but didn't seem to stress out the shellfish. A lot of ocean debris is "microplastic," or pieces smaller than five millimetres. These may be the beads from a facial scrub. fibres shed by synthetic clothing in the wash. or eroded remnants of larger debris. Compared to the number of studies investigating large-scale debris. Roclunan's group found little research on the effects of these tiny bits. There are also, she adds, a lot of open questions about the ways that ocean debris can lead to sea-creature death. Many studies have looked at how plastic affects an individual animal or that animal's tissues or cells, rather than whole populations. And in the lab, scientists often use higher concentrations of plastic than what's really in the ocean. None of that tells us how many birds or fish or sea turtles could die form plastic pollution or how deaths in one species could affect that animal's predators, or the rest of the ecosystem. "We need to be asking more ecologically relevant questions." Rothman says. Usually, scientists don't know how disasters like oil spills or nuclear meltdowns will affect the environment until after they've happened. she says. "We don't ask the right questions early enough." But if ecologists can understand how the slow-moving disaster of ocean garbage is affecting ecosystems. they might be able to prevent things from getting worse.Which ONE of the following conclusions based on the examination of the hundred-odd papers on marine debris and its ecological impact by Rachman and her colleagues is NOT CORRECT?
....

MCQ->Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit? A flip-flop is always a digital circuit. Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit. Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit. Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.Select the correct answer from the codes given below:....