1. A bar of uniform cross-section of 400 mm2 is loaded as shown in the figure. The stress at section 1-1 is





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Routine is not loaded until it is called. All routines are kept on disk in a relocatable load format. The main program is loaded into memory and is executed. This type of loading is called:....
QA->When the disposal is forwarded to record section what is to be obtained from record section by fair copy section:....
QA->On November 30, 2014, the Simon Wiesenthal Center reported that a senior Nazi figure who centrally involved in the implementation of the Holocaust had died in Syria around 2010, or four years earlier. Who is that Nazi figure?....
QA->Upon which development the Second Five Year Plan laid mote stress?....
QA->On which thing did the Buddhism and Jainism both give stress?....
MCQ->A mild steel bar of square cross-section 40 mm x 40 mm is 400 mm long. It is subjected to a longitudinal tensile stress of 440 N/mm2 and lateral compressive stress is 200 N/mm2 in perpendicular directions. E = 2 x 10-5 N/mm2, μ = 0.3. What is the approximate elongation of tht bar in the longitudinal direction ?....
MCQ->A compound bar consists of two bars of equal length. Steel bar cross-section is 3500 mm2 and that of brass bar is 3000 mm2. These are subjected to a compressive load 100,000 N. If Eb = 0.2 MN/mm2 and Eb = 0.1 MN/mm2, the stresses developed are:....
MCQ->A bar of uniform cross-section of 400 mm2 is loaded as shown in the figure. The stress at section 1-1 is....
MCQ->A shaft is subjected to a maximum bending stress of 80 N/mm2 and maximum shearing stress equal to 30 N/mm2 at a particular section. If the yield point in tension of the material is 280 N/mm2 and the maximum shear stress theory of failure is used, then the factor of safety obtained will be....
MCQ-> Read the data given below and answer the questions based on it. There were 3 sections namely A, B, and C in a test. Out of three sections, 33 students passed in Section A. 34 students passed in Section B and 32 passed in Section C. 10 students passed in Section A and Section B. 9 passed in Section B and Section C, 8 passed in Section A and Section C. The number of students who passed each section alone was equal and was 21 for each section.The ratio of the number of students passed in one or more of the sections to the number of students who passed in Section 7 A alone is:
 ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions