1. In hydrostatic testing of welded pipe (for leakage, strength etc.) the ratio of minimum hydrostatic test pressure to internal design pressure is around





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->THE WIND MOVING AROUND SPIRALLY AROUND A LOW PRESSURE AREA IS KNOWN AS....
QA->Highest useful compression ratio is the compression ratio at which the engine....
QA->The ratio of the age of two sisters is 3:The product of their ages is The ratio of their ages after 5 years will be:....
QA->The new company whichhas been set up to implement radio tag-enabled electronic toll collection(ETC)systems across all highways by March 2016 and has decided to make ETC lanes asa mandatory clause in the new highway building contracts.....
QA->What is the minimum strength of a State Legislative Assembly....
MCQ->In hydrostatic testing of welded pipe (for leakage, strength etc.) the ratio of minimum hydrostatic test pressure to internal design pressure is around....
MCQ->A tank has an inlet pipe and an outlet pipe. If the outlet pipe is closed then the inlet pipe fills the empty tank in 8 hours. If the outlet pipe is open then the inlet pipe fills the empty tank in 10 hours. If only the outlet pipe is open then in how many hours the full tank becomes half-full?....
MCQ->Two pipes A and B can fill an empty cistern in 4.8 and 7.2 hours, respectively. Pipe C can drain the entire cistern in 9.6 hours when no other pipe is in operation. Initially when the cistern was empty, Pipe A and Pipe C were turned on. After a few hours. Pipe A was turned off and Pipe B was turned on instantly. In all it took 16.8 hours to fill the cistern. For how many hours was Pipe B turned on?....
MCQ->Two pipes A and B can fill an empty cistern in 1.8 and 2.7 hours, respectively. Pipe C can drain the entire cistern in 4.5 hours when no other pipe is in operation. Initially when the cistern was empty Pipe A and Pipe C were turned on. After a few hours Pipe A was turned off and Pipe B was turned on instantly. In all it took 5.5 hours to fill the cistern. For how many hours was Pipe B turned on?....
MCQ->The maximum pressure which the pipe can withstand without any leakage during hydrostatic pressure test, is called....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions