Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in 049
Multiple Choice Question in
Multiple Choice Question in 2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Multiple Choice Question in -current-affairs-2016
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. Optimum economic pipe diameter for fluid flow is determined by the
(A): viscosity of the fluid.
(B): density of the fluid.
(C): total cost considerations (pumping cost plus fixed cost of the pipe).
(D): none of these.
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
Show Similar Question And Answers
QA->In case of firms having r>k, the optimum dividend policy requires …….pay out ratio.....
QA->Kerala Premo Pipe Factory Limited....
QA->Which are connected by over 1700 km-long BTC oil pipe-line?....
QA->Which are connected by over 1700 km-long BTC oil pipe-line ?....
QA->If the diameter of a circle is doubled, its area is increased by …… times.....
MCQ->For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)....
MCQ->Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation ?A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent.D. Fluid is compressible.E. Fluid is incompressible.....
MCQ->Optimum economic pipe diameter for fluid flow is determined by the....
MCQ->A tank has an inlet pipe and an outlet pipe. If the outlet pipe is closed then the inlet pipe fills the empty tank in 8 hours. If the outlet pipe is open then the inlet pipe fills the empty tank in 10 hours. If only the outlet pipe is open then in how many hours the full tank becomes half-full?....
MCQ->Two pipes A and B can fill an empty cistern in 4.8 and 7.2 hours, respectively. Pipe C can drain the entire cistern in 9.6 hours when no other pipe is in operation. Initially when the cistern was empty, Pipe A and Pipe C were turned on. After a few hours. Pipe A was turned off and Pipe B was turned on instantly. In all it took 16.8 hours to fill the cistern. For how many hours was Pipe B turned on?....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions