1. The capacity of a classifier in 'tons of solid/hr' is given by (where, A = cross-sectional area, m2 V = rising velocity of fluid, m/sec.S = percentage of solids in the suspension by volume.ρ = density of solids, kg/m3)





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->A cube has numerically equal volume and surface area. The volume of such a cube is :....
QA->An officer under suspension died before completion of disciplinary proceedings. The period of suspension will be treated as :....
QA->If the radius of a cylinder is doubled and the height is halved, what is the ratio between the new volume and previous volume?....
QA->The instrument used for measuring the density or relative density of liquids?....
QA->Which state is the percentage of forest area to total geographical area the highest?....
MCQ->The capacity of a classifier in 'tons of solid/hr' is given by (where, A = cross-sectional area, m2 V = rising velocity of fluid, m/sec.S = percentage of solids in the suspension by volume.ρ = density of solids, kg/m3)....
MCQ->For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)....
MCQ->Theoretical capacity of crushing rolls in tons/hr is given by (where, V = peripherial velocity, m/sec. W = width of rolls, m Dr = distance between rolls ρ = density of material to be crushed, kg/m3 here, V =πN.D where, N = speed of the rolls in rotation per second (rps) D = diameter of rolls, m)....
MCQ->A metallic solid is made up of a solid cylindrical base with a solid cone on its top. The radius of the base of the cone is 5 cm. and the ratio of the height of the cylinder and the cone is 3:2. A cylindrical hole is drilled through the solid with height equal to 2/$$3^{rd}$$ of the height of solid. What should be the radius (in cm) of the hole so that the volume of the hole is 1/$$3^{rd}$$ of the volume of the metallic solid after drilling?....
MCQ->A fluid jet of cross sectional area A and velocity V and density n strikes a flat plate moving with a velocity u.The fluid mass striking it per second is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions