1. The maximum thickness of the metal which can be welded using ultrasonic welding is __________ mm.





Write Comment

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->What is Maximum value of the wavelength of ultrasonic waves?....
QA->Kerala-based private sector lender Federal Bank is openingincubation centres for startups in __________ and __________.....
QA->Which rays can pass through 20 cm thickness of steel?....
QA->__________ is the metal having highest melting point....
QA->__________ is the metal having highest melting point.....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The maximum thickness of the metal which can be welded using ultrasonic welding is __________ mm.....
MCQ->When two metal pieces of different thicknesses are to be welded by projection welding, then the projections should be made on __________ metal piece.....
MCQ->Consider the following statements :1. Welded structures are usually lighter than riveted structures.2. Welding allows the arrangement of structural components in such a manner that the joint provides maximum efficiency.3. During welding, the members do not get distorted.Of these statements :....
MCQ->Filler material used in welding should have __________ as compared to the parent metal to be welded.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
DMCA.com Protection Status Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions