Which of the following statements are correct about the Bitwise & operator used in C#.NET? The & operator can be used to Invert a bit. The & operator can be used to put ON a bit. The & operator can be used to put OFF a bit. The & ?->(Show Answer!)

1. Which of the following statements are correct about the Bitwise & operator used in C#.NET? The & operator can be used to Invert a bit. The & operator can be used to put ON a bit. The & operator can be used to put OFF a bit. The & operator can be used to check whether a bit is ON. The & operator can be used to check whether a bit is OFF.

Write Comment

Comments

Tags

Show Similar Question And Answers

QA->…………….means the annual financial statements and other statements prescribed under Rule 65 of Kerala Panchayat Raj (Accounts) Rules, 2011?....

QA->As per Co-operative societies rule ‘Net profit’ means net profit as certified by :....

QA->Consider a Program Graph (PG) with statements as nodes and control as edges. Which of the following is not true for any PG?....

QA->The statements “Protoplasm is the physical basis of life” is given by which person?....

QA->Statements of affairs method is called or known as _____ method.....

MCQ->Which of the following statements are correct about the Bitwise & operator used in C#.NET? The & operator can be used to Invert a bit. The & operator can be used to put ON a bit. The & operator can be used to put OFF a bit. The & operator can be used to check whether a bit is ON. The & operator can be used to check whether a bit is OFF.....

MCQ-> Questions are based on a set of conditions. In answering some of the questions, it may be useful to draw a rough diagram. Choose the response that most accurately and completely answers each question. A BPO has assigned duty to nine operators - Abdulla, Ballal, Chandan, Dogra, Eshita, Falguni, Ganguli, Henri and Indra - on Monday, January 05, 2009 from 00:00 hours. Each operator commences duty at any of the following hours: 00:00 hrs, 04:00 hrs, 08:00 hrs, 12:00 hrs, 16:00 hrs and 20:00 hrs. At any point in time, at least one operator is required, to take clients' calls. Each operator works continuously for eight hours. All operators located at any single location start work simultaneously. The operators took training in five different colleges -Abhiman College, Sutanama College, Gutakal College, Barala College and Khatanama College. These colleges are located in the cities Jamshedpur, Pune, Noida, Hyderabad and Mangalore, not necessarily in that order. The operators operate from the cities where their respective colleges are located. Indra operates alone from a city other than Mangalore and Jamshedpur. Operator(s) trained in Abhiman College will start working at 12:00 hrs. Only Dogra and Falguni operate from Pune, but they are not trained in Gutakal College. Three of the operators took training from Sutanama College, and they operate from Noida. The operator(s) from Jamshedpur will start working at 0:00 hrs. Abdulla and Henri operate together as a two member team from a single location. They do not operate from Mangalore. No operator(s) will join at 20:00 hrs. Ballal, who alone operates from his location, was not trained in Barala College, and will commence his duty four hours after the operator(s) trained in Gutakal College. The operator(s) trained in Barala College operate from Hyderabad. The number of operator(s) trained in Khatanama College is same as the number of operator(s) trained in Barala College.Which of the following statements must be true?
....

MCQ-> In a modern computer, electronic and magnetic storage technologies play complementary roles. Electronic memory chips are fast but volatile (their contents are lost when the computer is unplugged). Magnetic tapes and hard disks are slower, but have the advantage that they are non-volatile, so that they can be used to store software and documents even when the power is off.In laboratories around the world, however, researchers are hoping to achieve the best of both worlds. They are trying to build magnetic memory chips that could be used in place of today’s electronics. These magnetic memories would be nonvolatile; but they would also he faster, would consume less power, and would be able to stand up to hazardous environments more easily. Such chips would have obvious applications in storage cards for digital cameras and music- players; they would enable handheld and laptop computers to boot up more quickly and to operate for longer; they would allow desktop computers to run faster; they would doubtless have military and space-faring advantages too. But although the theory behind them looks solid, there are tricky practical problems and need to be overcome.Two different approaches, based on different magnetic phenomena, are being pursued. The first, being investigated by Gary Prinz and his colleagues at the Naval Research Laboratory (NRL) in Washington, D.c), exploits the fact that the electrical resistance of some materials changes in the presence of magnetic field— a phenomenon known as magneto- resistance. For some multi-layered materials this effect is particularly powerful and is, accordingly, called “giant” magneto-resistance (GMR). Since 1997, the exploitation of GMR has made cheap multi-gigabyte hard disks commonplace. The magnetic orientations of the magnetised spots on the surface of a spinning disk are detected by measuring the changes they induce in the resistance of a tiny sensor. This technique is so sensitive that it means the spots can be made smaller and packed closer together than was previously possible, thus increasing the capacity and reducing the size and cost of a disk drive. Dr. Prinz and his colleagues are now exploiting the same phenomenon on the surface of memory chips, rather spinning disks. In a conventional memory chip, each binary digit (bit) of data is represented using a capacitor-reservoir of electrical charge that is either empty or fill -to represent a zero or a one. In the NRL’s magnetic design, by contrast, each bit is stored in a magnetic element in the form of a vertical pillar of magnetisable material. A matrix of wires passing above and below the elements allows each to be magnetised, either clockwise or anti-clockwise, to represent zero or one. Another set of wires allows current to pass through any particular element. By measuring an element’s resistance you can determine its magnetic orientation, and hence whether it is storing a zero or a one. Since the elements retain their magnetic orientation even when the power is off, the result is non-volatile memory. Unlike the elements of an electronic memory, a magnetic memory’s elements are not easily disrupted by radiation. And compared with electronic memories, whose capacitors need constant topping up, magnetic memories are simpler and consume less power. The NRL researchers plan to commercialise their device through a company called Non-V olatile Electronics, which recently began work on the necessary processing and fabrication techniques. But it will be some years before the first chips roll off the production line.Most attention in the field in focused on an alternative approach based on magnetic tunnel-junctions (MTJs), which are being investigated by researchers at chipmakers such as IBM, Motorola, Siemens and Hewlett-Packard. IBM’s research team, led by Stuart Parkin, has already created a 500-element working prototype that operates at 20 times the speed of conventional memory chips and consumes 1% of the power. Each element consists of a sandwich of two layers of magnetisable material separated by a barrier of aluminium oxide just four or five atoms thick. The polarisation of lower magnetisable layer is fixed in one direction, but that of the upper layer can be set (again, by passing a current through a matrix of control wires) either to the left or to the right, to store a zero or a one. The polarisations of the two layers are then either the same or opposite directions.Although the aluminum-oxide barrier is an electrical insulator, it is so thin that electrons are able to jump across it via a quantum-mechanical effect called tunnelling. It turns out that such tunnelling is easier when the two magnetic layers are polarised in the same direction than when they are polarised in opposite directions. So, by measuring the current that flows through the sandwich, it is possible to determine the alignment of the topmost layer, and hence whether it is storing a zero or a one.To build a full-scale memory chip based on MTJs is, however, no easy matter. According to Paulo Freitas, an expert on chip manufacturing at the Technical University of Lisbon, magnetic memory elements will have to become far smaller and more reliable than current prototypes if they are to compete with electronic memory. At the same time, they will have to be sensitive enough to respond when the appropriate wires in the control matrix are switched on, but not so sensitive that they respond when a neighbouring elements is changed. Despite these difficulties, the general consensus is that MTJs are the more promising ideas. Dr. Parkin says his group evaluated the GMR approach and decided not to pursue it, despite the fact that IBM pioneered GMR in hard disks. Dr. Prinz, however, contends that his plan will eventually offer higher storage densities and lower production costs.Not content with shaking up the multi-billion-dollar market for computer memory, some researchers have even more ambitious plans for magnetic computing. In a paper published last month in Science, Russell Cowburn and Mark Well and of Cambridge University outlined research that could form the basis of a magnetic microprocessor — a chip capable of manipulating (rather than merely storing) information magnetically. In place of conducting wires, a magnetic processor would have rows of magnetic dots, each of which could be polarised in one of two directions. Individual bits of information would travel down the rows as magnetic pulses, changing the orientation of the dots as they went. Dr. Cowbum and Dr. Welland have demonstrated how a logic gate (the basic element of a microprocessor) could work in such a scheme. In their experiment, they fed a signal in at one end of the chain of dots and used a second signal to control whether it propagated along the chain.It is, admittedly, a long way from a single logic gate to a full microprocessor, but this was true also when the transistor was first invented. Dr. Cowburn, who is now searching for backers to help commercialise the technology, says he believes it will be at least ten years before the first magnetic microprocessor is constructed. But other researchers in the field agree that such a chip, is the next logical step. Dr. Prinz says that once magnetic memory is sorted out “the target is to go after the logic circuits.” Whether all-magnetic computers will ever be able to compete with other contenders that are jostling to knock electronics off its perch — such as optical, biological and quantum computing — remains to be seen. Dr. Cowburn suggests that the future lies with hybrid machines that use different technologies. But computing with magnetism evidently has an attraction all its own.In developing magnetic memory chips to replace the electronic ones, two alternative research paths are being pursued. These are approaches based on:
....

MCQ->Match the following: List I (Bits operator in C) List II (Meaning) A.˜1.Bitwise XORB.&2.Bitwise ANDC.|3.Bitwise ORD.U4.One's complement

....

MCQ-> Read the following passage to answer the given question Some words have been printed in bold to help you to locate them while answering some of the questions. We tend to be harsh on our bureaucracy,but nowhere do citizens enjoy dealing with their government. They do it because they have to. But that doesn’t mean that the experience has to be dismal. Now there is a new wind blowing through government departments around the world, which could takes some of the pain away. In the next five years it may well transform not only the way public services are delivered but also the fundamental relationship between government and citizens. Not surprisingly, it is the Internet that is behind it. After e-commerce and e-business the next revolution may be e-governance. Examples abound. The municipality of Phoenix, Arizona, allows its citizens to renew their car registrations, pay traffic fines, replace lost identity cards etc. online without having to stand in endless queues in a grubby municipal office. The municipality is happy because it saves $5 a transaction it costs only $1.60 to do it across the counter. In Chile people routinely submit their income tax returns over the Internet Which has increased transparency, drastically reduced the time taken and the number of errors and litigation with the tax department. Both taxpayers and the revenue department are happier. The furthest ahead not surprisingly is the small, rich and entrepreneurial civil service of singapore which allows citizens to do more functions online than any other As in many private companies the purchasing and buying of Singapore’s government departments is now on the Web and cost benefits come through more competitive bidding easy access to global suppliers and time saved by online processing of orders. They can post their catalogues on their sites, bid for contracts submit in voices and check their payments status over the Net. The most useful idea for Indians municipalities is Gov Works a private sector site that collects local taxes fines and utility bills for 3,600 municipalities across the United States. It is citizen's site which provides information on government jobs, tenders, etc .The most ambitious is the British government, which has targeted to convert 100 per cent of its transactions with its citizens to the Internet by 2005. Cynics in India will say, 'Oh, e-government will never work in India. We are so poor and we dont have computers but they are wrong. There are many experiments afoot in India as well Citizens in Andhra Pradesh can download government forms and applications on the net without having bribe clerks.In many district land records are online and this had created transparency Similary, in Dhar district to Madhya Pradesh villagers have begun to file applications for land transfers and follow their progress on the net. In seventy village in the Kolhapur and Sangli districts in Maharashtra Internet booths have come up where farmers daily check the markets rates of agricultural commodities in Marathi along with data on agriculture schemes information on crop technology. When to spray and plant the crops and buds and railway timetables. They also find vocational guidance on jobs, applications for ration cards kerosene/gas burners and land records extracts with details of landownership. Sam pitroda’s World Tel, Reliance Industries and the Tamil Nadu government are jointly laying 3,000 km of optic fibre cables to create a, Tamil Network which will offers ration cards schools college and hospital admission forms land records and pension records. If successful World Tel will expand the network to Gujarat, Karnataka and West Bengal. In kerala all the villages are getting linked online to the district headquarters allowing citizens to compare the development properties of their village with other villagers in the state. Many are still skeptical of the real impact because so few Indians have computers. The answer lies in interactive cable T.V and in Internet kiosks, Although India has only five million computers and thirty-eight million telephones it has thirty four million homes with cable TV and these are growing eight percent a year By 2005 most cable homes will have access to the Internet from many of the 700,000 local STD/PCO booths. Internet usage may be low today, but it is bound to grow rapidly in the future, and e-government in India may not be a dream.According to the passage which country has the most ambitious plan for e-governance ?
....