Toggle navigation
Home
Article Category
Question Papers
General Knowlege
Popular Pages
Multiple Choice Question in
Multiple Choice Question in 049
Multiple Choice Question in 2016
Multiple Choice Question in -current-affairs-2016
Multiple Choice Question in TRADES-INSTRUCTOR---GR-II---SMITHY---TECHNICAL-EDUCATION
Question Answer in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in ASSISTANT-PROFESSOR---COMPUTER-SCIENCE-AND-ENGINEERING---TECHNICAL-EDUCATION
Multiple Choice Question in english
Multiple Choice Question in abbreviations-abbreviations-m
Multiple Choice Question in SSC CHSL 7 March 2018 Morning Shift
Multiple Choice Question in 072/2016
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
1. The slenderness ratio of a compression member is :
(A): $$\frac{Effective length}{Least radius of gyration}$$
(B): $$\frac{Actual length}{Moment of inertia}$$
(C): $$\frac{Moment of inertia}{Actual length}$$
(D): $$\frac{Actual length}{Radius of gyration}$$
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Write Comment
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Tags
RRB JE 2015 Paper
Show Similar Question And Answers
QA->Highest useful compression ratio is the compression ratio at which the engine....
QA->The ratio of the age of two sisters is 3:The product of their ages is The ratio of their ages after 5 years will be:....
QA->Piston compression rings are made of :....
QA->The resting time of heart during the interval of each compression is called....
QA->During adiabatic compression of a gas; what is the its temperature?....
MCQ->In a compression member, plate element may buckle locally before the entire member fails. To avoid this, which of the following recommendations are made ?1. Thickness of members is taken in terms of lengths of compression members2. Length of element is increased3. Length of member is increased4. Outstand is decreasedSelect the correct answer using the codes given below:....
MCQ->The following observation relate to designing of laced column :1. Single lacing systems on opposite planes shall preferably be in the same direction so that one is the shadow of the other.2. Lacing bar should only be a flat.3. The slenderness ratio of the lacing bars for compression shall not exceed 180.4. Laced compression members are to be provided with tie plates of ends.Of these observations :....
MCQ->The maximum permissible slenderness ratio of compression member carrying dead and superimposed load, is....
MCQ->Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed....
MCQ->The slenderness ratio of a compression member is :....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions