Go To Top Reset
I-GRADE-DRAFTSMAN-I-GR-OVERSEER---CIVIL---PUBLIC-WORKSIRRIGATION-HARBOUR-ENGINEERING-GROUND-WATER Related Question Answers
1. 1.Concurrent forces are those forces whose line of action?
Meet at one point Lie on the same line Meet on the same plane None of these
Disscuss This Question & Answer Add Tags Report Error Show Marks
2. 2.The angle between two forces when the resultant maximum and minimum respectively are?
0° and 180c 180° and 360° 90° and 180° 90° and 360°
Disscuss This Question & Answer Add Tags Report Error Show Marks
3. 3.When the spring of a watch is wound, it will posses
Strain Kinetic energy Heat energy Electrical energy
Disscuss This Question & Answer Add Tags Report Error Show Marks
4. 4.The moment of inertia of a rectangular section 3 cm wide and 4 cm deep about X-X axis is
9 cm4 12 cm4 16 cm4 20 cm4
Disscuss This Question & Answer Add Tags Report Error Show Marks
7. 7.The timber whose thickness is less than 5 cm and the width exceeds 12 cm, is called a
Board Plank Batten Log
Disscuss This Question & Answer Add Tags Report Error Show Marks
8. 8.A fine aggregate is one whose particle are of size
4.75 mm Below 4.75 mm 6.75 mm Above 6.75 mm
Disscuss This Question & Answer Add Tags Report Error Show Marks
9. 9.Seasoning of timber is done
To make it water proofing To heat it To paint it surfaces To remove water
Disscuss This Question & Answer Add Tags Report Error Show Marks
10. 10.Final setting time of cement should not more than
5 hours 10 hours 30 minutes 1 hour
Disscuss This Question & Answer Add Tags Report Error Show Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use
Powered By:Omega Web Solutions © 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions