DRAFTSMAN-GR-I-TOWN-PLANNING-SURVEYOR-GR-I---TOWN-AND-COUNTRY-PLANNING Related Question Answers

1. Structural steel sections are conforming to :

2. The minimum ultimate tensile strength of cold-twisted bar is :

3. For an over reinforced section :

4. Minimum shear reinforcement in the form of stirrups shall be provided in accordance with the relation :Ase fy

5. The development length Ld lor bars in tension is given by :

6. Maximum horizontal distance between tension bars in case of beams for mild steel:

7. For the design of one way slab, main steel reinforcement A5t is obtained by :

8. For two way slab long span, short span ratio should be :

9. The minimum number of longitudinal bars provided in a circular column :

10. The diameter ot longitudinal bars in column should nol be less than :

11. The way in which the force is acting :

12. When the forces in a force system lie in the same plane and have the same line of action, then the fome system is called :

13. The maximum angle of inclination of the plane at which a body remain in equilibrium under the action of friction only :

14. The area of a semi-circle is :

15. The centre of gravity of a hemisphere from the base is at a distance of

16. If the load applied on a steel wire of diameter 4 mm is 40 N, then the stress in the body is equal to :

17. Volumetric strain of a rectangular body subjected to an axial force is :

18. If the linear strain is 0.00045 and lateral slrain is 0.00015, the poisson's ratio is ecpnal to :

19. The maximum strain energy stored in a body is known as :

20. The maximum deflection for a singly supported beam with a central coventrated load is :W I2w/3w/2w /3

21. The distance between 2 points measured by a 20 m chain was recorded as 80 m. If the chain used was 10 cm too long, correct distance is :

22. Correction for pull is obtained by the equation :

23. If the length of two parallel sides of a trapezium are 40 m and 60 m respectively and its perpendicular distance is 15 m, then its area is :

24. If the whole circle bearing of a line is 332c 23' its quadrantal bearing is :

25. If the bearings of two lines OA and OB meeting at 'O' is N 250 40' E and S 45° 25' E. its included angle is :

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use